ADVrider

ADVrider (http://www.advrider.com/forums/index.php)
-   Parallel Universe (http://www.advrider.com/forums/forumdisplay.php?f=77)
-   -   AFAM quality? Made where? best CS sprocket that will not chew up the shaft? (http://www.advrider.com/forums/showthread.php?t=812708)

BMWf800gs 07-29-2012 11:39 AM

AFAM quality? Made where? best CS sprocket that will not chew up the shaft?
 
OEM only?
Or is some after market just as good and cheaper?
Non communist made sprocket and chains of top quality? for the f800GS.
Thank you.

itsatdm 07-29-2012 07:12 PM

http://www.touratech-usa.com/Store/2...win-F800GS-16T

They be made in a former Communist country. If you go this route, buy the higher priced version. I bought the lower cost 15 tooth and it has an as cast appearance and a very tight fit. Same source 17th higher cost sprocket, had a more finished look and fit like stock.

14TLC 07-30-2012 05:12 AM

You can try JT Sprockets. High quality and not very expensive.

http://www.jtsprockets.com/

For the chain you can check Regina, RK, D.I.D

Bucko 08-01-2012 03:51 PM

I'm running the 17T from TouraTech. Put it on at about 12k miles and it looked so good when I replaced the stock chain at 26k that I left it there. Haven't noticed any shaft damage.

markymcd 08-01-2012 07:01 PM

I've got the 18T AFAM. the quality looks great but it was a bitch to get it on. And a lost cause trying to get it off without a puller. Way too snug.

Mark

Dorito 08-02-2012 07:35 AM

Well here's one not to get:

Ancedotal evidence against Drive Systems USA


Times are GMT -7.   It's 07:37 PM.

Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014