ADVrider

ADVrider (http://www.advrider.com/forums/index.php)
-   2 smokers (http://www.advrider.com/forums/forumdisplay.php?f=84)
-   -   TC125 falling on it's face - timing? (http://www.advrider.com/forums/showthread.php?t=821945)

skeelo221 08-29-2012 08:26 PM

TC125 falling on it's face - timing?
 
Hello,

I picked up a 1972 TC125 last year that was in mint condition. It's an awesome bike and I love riding it! Sadly, I don't know much at all about 2 strokes. Here's whats happening:

The bike falls on it's face when I give it more than 1/2 or 3/4 throttle at any RPM. It sounds like it's bogging down (like when it's running out of gas). This reaks of a carburation issue to me so I took about the carb and cleaned everything but I didn't see anything wrong (especially a clogged main). What's also strange is that it will fall on it's face in the same manner even under very slight throttle opening as the revs get above ~6k rpm indicated. Rev counter shows 9k redline I believe.

So, it seems like it's both throttle position and RPM based. No idea what it could be other than timing which I think I would have to take into the shop cause I know nothing about setting timing.

Any help would be appreciated!

Twin-shocker 08-30-2012 01:18 AM

Try fitting new points and condenser, if you are 100% certain the carb is completely clean.

skeelo221 08-30-2012 09:31 AM

Thanks for your reply!

One more thing to add is that it happened "all of a sudden." I was riding the bike almost daily with no issues and then this started happening suddenly one day - so not like it was sitting in a barn for years and the carb had time to collect varnish.

What tools do you need to pull the flywheel on these bikes? Is there a specific flywheel puller that you need or can you do it with standard hand tools?

Also what should the point gap be on these motors (sorry I don't have a manual)

Twin-shocker 08-30-2012 11:11 AM

You need a flywheel puller, and ideally an air gun to remove the flywheel nut. Without a gun you are going to need something to stop the flywheel turning, when you undo the nut with a ratchet.


Times are GMT -7.   It's 04:15 AM.

Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014