ADVrider (
-   Airheads (
-   -   Drive shaft (

kellymac530 11-01-2012 04:46 PM

Drive shaft
I am looking at extending a swing arm on an R80G/S and I want to do the method of using 2 drive shafts with one weld rather than a splice with 2 welds.

Are the U-joint ends on all R60 R80 R90 R100 driveshafts the same size?

I have a line on a couple of shafts and don't want to waste my money if the U-joints are different

kellymac530 11-01-2012 04:50 PM

Is it also the same U-joint end on a /2?

Times are GMT -7.   It's 12:58 AM.

Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2015