Long term storage 1975 R90/6
I have a 1975 R90/6 that I have removed the carbs, fenders, gas tank, seat, etc. Basically, it's just a frame, engine, transmission, drivetrain, wheels, tires and handlebars.
The engine is in great shape, about 37,000 miles. No problems with anything as far as I know. I used this as a donor bike to refurbish my other '75. The reason this was the donor bike was because the paint job on this one was horrendous. Also had the Lufty fairing, etc. Ugly, but in great shape. Engine is pretty clean, no grease, oil stains, etc.
Anyhow, my original plan was to sell this to a parts supplier or on ebay, craigslist, etc.
The more I think about it, the more I wonder if it would be best to hang on to it. It would probably make a fun project to refurbish it someday. However, right now I am doing a '74 Norton Commando.
So, I am asking what steps I can take to make sure it's stored properly. It still has all of the fluids in the engine, tranny, etc. Should I drain everything? Fill everthing to the brim? Spray something in the cylinders? Open as many drains, holes, etc. so it can breathe? Or should I button it up tight to try and keep moisture out of it? It will be stored in a waterproof area, but subject to ambient temperatures 0 degrees to 100 degrees.
Should I take the wheels and tires off or just jack it up?
Any comments or suggestions would be much appreciated....
|Times are GMT -7. It's 04:10 AM.|
Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2015