Throttle body repair kit help
I've just started to repair the left hand TB on my 2002 R1150GS Adv with one of Dan's kits.
Unfortunately the throttle quadrant is of a different design to the one shown in his step-by-step guide.
The nut that hols on the shaft is not on this TB so don't know how to proceed.
Anyone done this with this type of TB?
That's a snap ring, should be able to remove that and proceed as normal.
According to the photo guide the shaft comes out that side
Response from Dan:
No problem there :)
the pics you saw on advrider were from an early 1100 bike, hence the
outer nut. I have changed that design to the one you have now for all TB
repair kits types, so they all look the same now, with an inner M3
thread (that's why the M3 screw and large washer is in for)
You have to punch the old shaft out, using something smaller than 5 mm
|Times are GMT -7. It's 10:21 PM.|
Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014