ADVrider

ADVrider (http://www.advrider.com/forums/index.php)
-   GS Boxers (http://www.advrider.com/forums/forumdisplay.php?f=3)
-   -   OEM crash bars (http://www.advrider.com/forums/showthread.php?t=861145)

WADE-O 02-05-2013 09:10 PM

OEM crash bars
 
I bought a set of used OEM crash bars but they came with no instructions. Are they any specific torque values that i need to use or anything like. Thanks

WADE-O

qman8 02-06-2013 06:48 AM

Quote:

Originally Posted by WADE-O (Post 20660090)
I bought a set of used OEM crash bars but they came with no instructions. Are they any specific torque values that i need to use or anything like. Thanks

WADE-O

Dont have the instructions with me at the moment, but as I remember, yes...there are torque specs for the bolts that thread into the motor housing. Also, check them again after a hundred miles or two, as mine seemed to have worked themselves out somewhat...which caused (more than normal) vibration at the handlebars.

Swinefahrt 02-07-2013 04:37 AM

I got this from r1200gs.com


Crash bar buffer to crankcase, M6 8 Nm (6 ft-lbs)
Crash bar to engine, front right, M6 x 10, with loose washer 8 Nm (6 ft-lbs)
Silentbloc to engine, M8 19 Nm (14 ft-lbs)
Crash bar to engine, rear left and right, Hex nut M8 19 Nm (14 ft-lbs)
Crash bar to engine, front left, M8 x 16 19 Nm (14 ft-lbs)

WADE-O 03-01-2013 02:48 PM

Does anyone have a detailed picture heavy look and how to put the bars cause as i am looking at the hardware it came with it seems like i have extra stuff. I just wanna make sure that i do it the correct way the first time. Thanks.


Times are GMT -7.   It's 08:42 PM.

Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014