ADVrider

ADVrider (http://www.advrider.com/forums/index.php)
-   Vendors (http://www.advrider.com/forums/forumdisplay.php?f=18)
-   -   Base plate for KTM 990 ITG foam air filter. (http://www.advrider.com/forums/showthread.php?t=866394)

gefr 02-27-2013 12:48 AM

Base plate for KTM 990 ITG foam air filter.
 
Aluminum base plate cut with laser for KTM 990 ITG Superflow foam air filter. Matches with ITG JC30/65 and JC30/80 model.

Cost will be 45€, shipping is free.
It can take up to 22 days to reach buyers, though it usually reaches USA in 10 days.

Upper side:
http://i1068.photobucket.com/albums/...psec6eee15.jpg

Lower side:
http://i1068.photobucket.com/albums/...ps50266a3a.jpg

Plates without the breather hole and/or without temp sensor are now available, you just need to ask them specifically.

http://i1068.photobucket.com/albums/...pse75c7133.jpg
I can also include blanking plates with another 5€.

DZUS half turn clips and sealing flanges for throttle bodies are included. Sealing flanges should be fitted under the base plate.

Foam filters are not included. You can find a local distributor here:

http://www.itgairfilters.com/megaflow-introduction.asp

rossguzzi 05-07-2013 02:07 AM

Do they fit in the airbox? Or would I put the lid of the airbox back on?

gefr 05-07-2013 02:11 AM

No they replace the whole airbox completely.
 
The base plate sits on the throttle bodies. Τhe foam filter attaches on the base plate.
Cheers.

LocuL 05-07-2013 11:26 AM

Could/would you make any for the RC8.

gefr 05-07-2013 11:36 AM

Mmm interesting thought.
 
It will take a while though... let me put this into perspective...

alongat 06-04-2013 04:29 AM

GEFR, I want one of these for my 990ADV - how do I place an order with you? If you prefer, feel free to email me offline at alongat.gat@gmail.com

Thank you


Times are GMT -7.   It's 06:01 PM.

Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014