ADVrider

ADVrider (http://www.advrider.com/forums/index.php)
-   Orange Crush (http://www.advrider.com/forums/forumdisplay.php?f=34)
-   -   Clutch push rod (http://www.advrider.com/forums/showthread.php?t=877715)

990s 04-10-2013 04:43 AM

Clutch push rod
 
Hi does anyone know the correct length of the clutch push rod (60032054400) ?
My clutch wont disengage proberly, i cant find anything wrong anywere(slave,booster,
disks etc) but the rod seems to have taken some beating in the clutch slave end that might have shortened it. Thanks!

gefr 04-10-2013 06:15 AM

There have been some different length editions.
 
I suggest you try installing a spacer and see what happens.
Cheers.

990s 04-15-2013 10:37 AM

Quote:

Originally Posted by gefr (Post 21151872)
I suggest you try installing a spacer and see what happens.
Cheers.

Thanks!
but how?

gefr 04-15-2013 12:19 PM

In the clutch slave culinder
 
You will have to unbolt the slave cylinder on the left side of the bike and install a washer in the end of the pushrod. However the liquid clutch assembly is there to compensate small changes by usint supplementary hydraulic liquid from the liquid tank. Are you sure you are not experiencing clutch slave cylinder failure?

http://advrider.com/forums/showthrea...171986&page=30

Sevv 04-15-2013 12:42 PM

A small air bubble in the line will cause this...

990s 04-15-2013 02:41 PM

I have changed the slave, and i think i have all the air out of the system. It is not to expensive to change the rod (23 euro). It is kind of battled and worn on the slave (thin) side. Since i think it might affect its performance i will probebly just change it... Cheers!


Times are GMT -7.   It's 06:56 AM.

Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014