ADVrider

Go Back   ADVrider > Search Forums
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Showing results 1 to 40 of 71
Search took 0.01 seconds.
Search: Posts Made By: Jorik
Forum: GS Boxers 01-21-2015, 11:06 AM
Replies: 10
Views: 613
Posted By Jorik
Ignition.

Ignition.
Forum: GS Boxers 01-04-2015, 04:28 PM
Replies: 17
Views: 1,377
Posted By Jorik
Yes, thin walled but nothing special. OEM spark...

Yes, thin walled but nothing special. OEM spark plug socket for hexhead is OK or any other 16mm hextube socket with thin wall. I had not both of them so I took suitable round tube and made one side...
Forum: GS Boxers 01-03-2015, 02:48 PM
Replies: 17
Views: 1,377
Posted By Jorik
There is no intrigue. Denso's were installed...

There is no intrigue.
Denso's were installed as primary without specific reason just noted for protocol.
The shop where plugs were purchased had only 2pc Denso's and 3pc NGK's.
I think they are...
Forum: GS Boxers 01-03-2015, 03:16 AM
Replies: 30
Views: 1,657
Posted By Jorik
NGK CR8EIX and Denso IU24 instead NGK MAR8B-JDS...

NGK CR8EIX and Denso IU24 instead NGK MAR8B-JDS working just fine in my camhead for the past 25000 km.
http://advrider.com/forums/showpost.php?p=24192818&postcount=1
Forum: Ride reports 12-21-2014, 07:27 AM
Replies: 7
Views: 1,057
Posted By Jorik
Excellent video, nice editing! Solo&Tent is very...

Excellent video, nice editing! Solo&Tent is very good setup.
Forum: Thumpers 09-10-2014, 02:14 AM
Replies: 3
Views: 602
Posted By Jorik
Akrapovic FI map with F-L switch 10,10,0,0,0,0,0...

Akrapovic FI map with F-L switch 10,10,0,0,0,0,0 + AMa's EP maps modifications work good for me (2011, stock airfilter-airbox + LeoVince exhaust ):...
Forum: GS Boxers 08-04-2014, 12:52 PM
Replies: 10
Views: 1,194
Posted By Jorik
Did you consider Wilbers-WESA?

Did you consider Wilbers-WESA?
Forum: GS Boxers 07-23-2014, 03:38 PM
Replies: 32
Views: 1,776
Posted By Jorik
+ good min 10 bar Normal ...

+
good
min 10 bar

Normal
8.5...10 bar

poor
max 8.5 bar
Forum: GS Boxers 05-18-2014, 02:48 PM
Replies: 17
Views: 1,377
Posted By Jorik
Iridium spark plugs instead NGK MAR8b-JDS for camhead

Hi,

Perhaps someone will be interested. Bike is 2010 camhead.

Expecting prolonged life of iridium's spark plugs I changed stock plugs NGK MAR8B-JDS with Denso IU24 as primary and NGK CR8EIX as...
Forum: Ride reports 05-14-2014, 02:00 PM
Replies: 9
Views: 2,616
Posted By Jorik
Great trip! In the spring of 2012 I had about...

Great trip!
In the spring of 2012 I had about the same route in Morocco with bias towards mountain roads to the North-East from Qurzazate. Beautiful country and friendly locals.
Thank you for...
Forum: GS Boxers 04-27-2014, 01:33 PM
Replies: 48
Views: 6,430
Posted By Jorik
Today two Denso IU24 plugs (iridium) were...

Today two Denso IU24 plugs (iridium) were installed on camhead engine instead stock plugs NGK MAR8B-JDS as two primary for test in anticipation of life prolongation.
Secondary plugs are stock so...
Forum: GS Boxers 04-22-2014, 01:10 PM
Replies: 4
Views: 610
Posted By Jorik
Throttle body synch - Those 4 columns are...

Throttle body synch - Those 4 columns are independent so block or open unused columns - doesn't matter.
Forum: Ride reports 02-21-2014, 02:10 PM
Replies: 94
Views: 29,824
Posted By Jorik
Hei, Great ride! Intrigue. What further? I'm...

Hei,

Great ride! Intrigue. What further? I'm worried about Jani's condition and O2 sensor of your bike.

.
Forum: Ride reports 02-13-2014, 10:23 AM
Replies: 48
Views: 8,792
Posted By Jorik
Thanks for sharing your great RR. Thinking to...

Thanks for sharing your great RR. Thinking to visit Albania this summer. Now Romania is also in my trip list.
Forum: Ride reports 02-09-2014, 12:27 PM
Replies: 48
Views: 8,792
Posted By Jorik
Subscribed!

Subscribed!
Forum: GS Boxers 01-12-2014, 02:31 AM
Replies: 18
Views: 1,417
Posted By Jorik
Privet, Russian is more easy for me :) I'll...

Privet,

Russian is more easy for me :) I'll send you PM with detailed info tomorrow.
Forum: GS Boxers 01-11-2014, 12:39 PM
Replies: 18
Views: 1,417
Posted By Jorik
"Manufactured in Feb 2010" This bike...

"Manufactured in Feb 2010"

This bike probably had recall concerning wrong camshafts position in right head (not big problem I corrected it myself) so check service book or ask owner.
Forum: GS Boxers 01-05-2014, 12:45 PM
Replies: 5
Views: 936
Posted By Jorik
Hi, All info in your ohlins's link so BM 943...

Hi,

All info in your ohlins's link so BM 943 for you.
Forum: GS Boxers 11-29-2013, 04:08 PM
Replies: 6
Views: 801
Posted By Jorik
+ Both throttle valves MUST reach their idle...

+
Both throttle valves MUST reach their idle stops on TB before and after synchronizing. Check this. If this is Ok and both cables have some free play (slack) but idle still low and probably...
Forum: Thumpers 11-15-2013, 02:55 PM
Replies: 1,253
Views: 175,581
Posted By Jorik
Not 100% sure but one of these "digital grounds"...

Not 100% sure but one of these "digital grounds" of map and aap sensors actually may be power/ref voltage (bu, blue)? another one (bl, black)? is ground.

.
Forum: GS Boxers 11-05-2013, 03:21 PM
Replies: 8
Views: 841
Posted By Jorik
I assume you mean our stock narrow band sensor. ...

I assume you mean our stock narrow band sensor.
4 wires - 2 (black, grey) are sinal and 2 (white) are heater.
Signal swings between ~0.1V-0.9V. Below 0.4V - lean mixt, above 0.5V - rich. ...
Forum: GS Boxers 10-09-2013, 03:15 AM
Replies: 362
Views: 164,124
Posted By Jorik
It is Great! .

It is Great!

.
Forum: Equipment 08-04-2013, 04:12 PM
Replies: 23
Views: 2,141
Posted By Jorik
Sennheiser CX 300-II or CX 400-II

Sennheiser CX 300-II or CX 400-II
Forum: GS Boxers 08-04-2013, 03:32 PM
Replies: 13
Views: 758
Posted By Jorik
RSD - 180ml

RSD - 180ml
Forum: GS Boxers 07-18-2013, 08:18 AM
Replies: 7
Views: 753
Posted By Jorik
Measured. 10mm is max in reality.

Measured. 10mm is max in reality.
Forum: GS Boxers 07-17-2013, 03:17 PM
Replies: 7
Views: 753
Posted By Jorik
Justs looked RSD for 2010GSA with SHOWA ESA (my)....

Justs looked RSD for 2010GSA with SHOWA ESA (my). 10 mm is max rear preload for both modes "rider with passenger" and "maximum offroad"... So don't hurry with cover.
Where is true I'll measure...
Forum: GS Boxers 07-17-2013, 12:22 PM
Replies: 7
Views: 753
Posted By Jorik
http://www.mts1200.info/bmw_r1200gs/suspension/esa...

http://www.mts1200.info/bmw_r1200gs/suspension/esa_rider_guide.htm
Forum: GS Boxers 07-10-2013, 03:41 PM
Replies: 3,233
Views: 1,075,901
Posted By Jorik
Great! Is it road 258? .

Great! Is it road 258?


.
Forum: GS Boxers 05-19-2013, 02:27 AM
Replies: 1
Views: 386
Posted By Jorik
25

25
Forum: GS Boxers 05-09-2013, 05:11 AM
Replies: 7
Views: 605
Posted By Jorik
BmwMotorrad Anatomy Textbook :rofl or from RSD....

BmwMotorrad Anatomy Textbook :rofl or from RSD. I don't remember exactly.

.
Forum: GS Boxers 05-09-2013, 05:00 AM
Replies: 7
Views: 605
Posted By Jorik
https://lh3.googleusercontent.com/-znLm57W3b-E/UYt...

https://lh3.googleusercontent.com/-znLm57W3b-E/UYt_uuoZyLI/AAAAAAAAALo/XfhTUEvV7u8/w410-h306-p-o/1.jpg
...
Forum: GS Boxers 05-09-2013, 02:26 AM
Replies: 7
Views: 605
Posted By Jorik
Bracket.

Bracket.
Forum: GS Boxers 04-25-2013, 05:48 PM
Replies: 8
Views: 962
Posted By Jorik
Only last line.

Only last line.
Forum: GS Boxers 04-25-2013, 03:43 PM
Replies: 8
Views: 962
Posted By Jorik
Resistance ~800 Ohm any polarity. Also if you...

Resistance ~800 Ohm any polarity.
Also if you connect sensor to mV_meter and touch few times that magnet core by the bolt or screwdriver - you should see pulsation of voltage.
It's not 100% test....
Forum: GS Boxers 04-09-2013, 02:30 PM
Replies: 3,799
Views: 603,864
Posted By Jorik
It's clear now. Thanks!

It's clear now. Thanks!
Forum: GS Boxers 04-09-2013, 04:09 AM
Replies: 3,799
Views: 603,864
Posted By Jorik
Hello Poolside, I've made my own temperature...

Hello Poolside,

I've made my own temperature shifter (more simple then IICE Air, non-switchable and not so perfect temp. curve). Still not use it due to weather condition. When I started make this...
Forum: GS Boxers 04-08-2013, 11:04 AM
Replies: 3,799
Views: 603,864
Posted By Jorik
Hi, Could ECU (BMS-K on R1200 2010-12 O2...

Hi,

Could ECU (BMS-K on R1200 2010-12 O2 sensors connected) correct temperature shifting wich IICE Air does after few times due to its adaptation ability?

BR
Forum: GS Boxers 03-31-2013, 01:40 PM
Replies: 77
Views: 5,912
Posted By Jorik
This + try to hold shaft straight by screwdriver...

This + try to hold shaft straight by screwdriver inserted into u-joint.
Forum: GS Boxers 02-12-2013, 04:28 AM
Replies: 18
Views: 1,508
Posted By Jorik
+1 ;)

+1 ;)
Forum: GS Boxers 02-12-2013, 03:29 AM
Replies: 18
Views: 1,508
Posted By Jorik
Kevin, I've already had this problem....

Kevin,

I've already had this problem. Perhaps finishing calibration procedure was incorrectly (probably you switched off the engine before finish cal. procedure in gs911 soft). "Reset all...
Showing results 1 to 40 of 71

 
Forum Jump

Times are GMT -7.   It's 03:35 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2015