ADVrider

Go Back   ADVrider > Search Forums
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Showing results 1 to 40 of 500
Search took 0.05 seconds.
Search: Posts Made By: stainlesscycle
Forum: The Garage Today, 01:31 PM
Replies: 46
Views: 1,806
Posted By stainlesscycle
in case anyone needs a real truck. here's...

in case anyone needs a real truck.


here's one for sale. i was very tempted.


http://www.stainlesscycle.com/ambu/ih1710.jpg
Forum: The Garage Today, 12:44 PM
Replies: 46
Views: 1,806
Posted By stainlesscycle
that is the plan.

that is the plan.
Forum: The Garage Today, 12:28 PM
Replies: 46
Views: 1,806
Posted By stainlesscycle
p.s. anyone need a red lightbar? or a vanner...

p.s. anyone need a red lightbar? or a vanner flasher unit? :rofl
Forum: The Garage Today, 12:11 PM
Replies: 46
Views: 1,806
Posted By stainlesscycle
bought it. got a nice price on it. will do a...

bought it. got a nice price on it. will do a long test drive tomorrow i guess.

only 2 issues i have found:
a: 1 rear wheel cylinder leaking. - no big deal, just gotta figure out how i'm...
Forum: The Garage Yesterday, 08:03 PM
Replies: 46
Views: 1,806
Posted By stainlesscycle
yes, but i need to have 3 minimum inside, or it's...

yes, but i need to have 3 minimum inside, or it's not worth it to me. i lose almost no storage if i pull out the passenger side bed.
Forum: The Garage Yesterday, 02:43 PM
Replies: 46
Views: 1,806
Posted By stainlesscycle
thats the plan. tomorrow going to go over it...

thats the plan. tomorrow going to go over it much closer.
Forum: The Garage Yesterday, 02:16 PM
Replies: 46
Views: 1,806
Posted By stainlesscycle
pics. ...

pics.

http://www.stainlesscycle.com/ambu/100_0564.jpg

http://www.stainlesscycle.com/ambu/100_0565.jpg

http://www.stainlesscycle.com/ambu/100_0566.jpg
...
Forum: 2 smokers 11-22-2014, 01:43 PM
Replies: 2
Views: 184
Posted By stainlesscycle
487 is 1974 dt125F A/B. - should be same as 444...

487 is 1974 dt125F A/B. - should be same as 444 cases i believe - usa was dt125a/b

try

http://www.yamahamotorsports.com/partviewer/default.aspx?ls=sport

and select motorcycle/1974/dt125 -...
Forum: The Garage 11-22-2014, 01:08 PM
Replies: 46
Views: 1,806
Posted By stainlesscycle
i believe it's got an hour meter on the dash -...

i believe it's got an hour meter on the dash - will have to look. i wondered the same thing, i figured it sat and idled all day, will do more investigation of it on monday.. to the best of my...
Forum: The Garage 11-22-2014, 01:00 PM
Replies: 46
Views: 1,806
Posted By stainlesscycle
some good stuff there - i'm hoping mine is...

some good stuff there - i'm hoping mine is significantly less extensive - a boot rack would be killer. i'd like to have: 20 gal+ water tank + pressure washer, some kind of inverter, a dirty gear...
Forum: The Garage 11-22-2014, 08:26 AM
Replies: 46
Views: 1,806
Posted By stainlesscycle
that's what i had assumed i would do. (2) 2"...

that's what i had assumed i would do. (2) 2" square tube to frame rails, then aluminum rails on a steel frame that 'plugs into' the 2 pieces of square tube.
Forum: The Garage 11-22-2014, 07:33 AM
Replies: 46
Views: 1,806
Posted By stainlesscycle
this vehicle has some auxilliary lighting built...

this vehicle has some auxilliary lighting built in :rofl
Forum: The Garage 11-22-2014, 06:48 AM
Replies: 46
Views: 1,806
Posted By stainlesscycle
i've looked through many of those threads - lots...

i've looked through many of those threads - lots of good information.
Forum: The Garage 11-22-2014, 06:44 AM
Replies: 46
Views: 1,806
Posted By stainlesscycle
yes, i agree, but i already have 2 trailers, and...

yes, i agree, but i already have 2 trailers, and don't need another :)

just trying to be all in one self enclosed. i'll be selling an older truck off, and will have no problem driving this ambo...
Forum: The Garage 11-22-2014, 06:41 AM
Replies: 46
Views: 1,806
Posted By stainlesscycle
yes, local to us. vehicle sat on site at charles...

yes, local to us. vehicle sat on site at charles town race track for the last few years. a relative of a friend is a used/new ambulance dealer. came as a trade in on a newer one.... there's...
Forum: The Garage 11-22-2014, 06:03 AM
Replies: 46
Views: 1,806
Posted By stainlesscycle
no indoor storage for this one - i might be able...

no indoor storage for this one - i might be able to find indoor storage over the winter....
Forum: The Garage 11-22-2014, 05:52 AM
Replies: 46
Views: 1,806
Posted By stainlesscycle
i do 20-25+ weekends a year, average 300-800...

i do 20-25+ weekends a year, average 300-800 miles round trip. so easily 10-20k miles a year..

i've checked out as much as i can about that motor - it appears the pmd is the biggest issue. don't...
Forum: The Garage 11-22-2014, 05:30 AM
Replies: 46
Views: 1,806
Posted By stainlesscycle
trying to avoid a trailer - i have considered 3...

trying to avoid a trailer - i have considered 3 bikes inside, and 1 on a bumper rail.... i have sworn off pop up tents. i was considering an rv type awning...


any chance i will get better...
Forum: The Garage 11-22-2014, 02:03 AM
Replies: 46
Views: 1,806
Posted By stainlesscycle
i don't have pics of the ambulance, but this is...

i don't have pics of the ambulance, but this is the exact same model.

http://us.browdermetals.com/cgi-bin/md/M10027/s3.pl


in the back i can take the interior out on the driver side up to the...
Forum: The Garage 11-21-2014, 11:57 AM
Replies: 46
Views: 1,806
Posted By stainlesscycle
ambulance for hauling bikes?

i've been looking for a better vehicle to haul 4 bikes to races. my current setup is dirt cheap and efficient for 3 bikes. i also have a truck and trailer setup that will easily haul 7-8 bikes. i...
Forum: The Garage 11-19-2014, 08:42 AM
Replies: 20
Views: 1,027
Posted By stainlesscycle
if you could use an ice chest, and it does not...

if you could use an ice chest, and it does not need to be warm and just above freezing i would skip the core all together, just run a coil or 2 of the heater line in the bottom of the ice chest. ...
Forum: Thumpers 11-16-2014, 12:33 PM
Replies: 8
Views: 347
Posted By stainlesscycle
i have torn down some flat slides too far - but...

i have torn down some flat slides too far - but you have to replace bad o-ring type gaskets - i have had success with o-ring maker fluid, although it's a pain in the ass. there are gaskets that are...
Forum: The Garage 11-15-2014, 06:00 AM
Replies: 23
Views: 1,745
Posted By stainlesscycle
there is a ditch to left of first picture. i...

there is a ditch to left of first picture. i even dug some channels from the drive to the ditch to pull water away. the ditch is at least 2' wide and 1' deep. it fills completely after a rain...
Forum: The Garage 11-14-2014, 12:39 PM
Replies: 23
Views: 1,745
Posted By stainlesscycle
done the crushed rock, doesn't work - need much...

done the crushed rock, doesn't work - need much bigger... even if graded, the trucks push it off the drive..

100 tons of rock would just be wasted unless they were big (like bigger than softball)....
Forum: The Garage 11-14-2014, 12:37 PM
Replies: 23
Views: 1,745
Posted By stainlesscycle
yes, big rocks = concrete bags that are hardened....

yes, big rocks = concrete bags that are hardened. perhaps i should just get some bags of concrete, stack them outside, and wait till they get hard - maybe all winter?. then place them in the...
Forum: The Garage 11-14-2014, 09:35 AM
Replies: 23
Views: 1,745
Posted By stainlesscycle
driveway is not properlycrowned, nor will it ever...

driveway is not properlycrowned, nor will it ever be. it's 400 yards long i would guess. there's no way to keep traffic off it more than a day or 2 max. there's 2 other families that use the...
Forum: The Garage 11-13-2014, 11:33 AM
Replies: 23
Views: 1,745
Posted By stainlesscycle
Concrete bags as forms?

So I have these big divots in my driveway (gravel/dirt). - have filled them many times. They sink from the delivery trucks coming up here everyday. I was thinking about filling holes by laying...
Forum: 2 smokers 11-07-2014, 07:03 AM
Replies: 116
Views: 5,401
Posted By stainlesscycle
i wouldn't consider a kdx a modern bike... even...

i wouldn't consider a kdx a modern bike... even the last generation is worlds behind what is current.
Forum: 2 smokers 11-04-2014, 12:22 PM
Replies: 4
Views: 543
Posted By stainlesscycle
pm'd you.

pm'd you.
Forum: 2 smokers 11-04-2014, 09:12 AM
Replies: 4
Views: 543
Posted By stainlesscycle
i have a bottom end that looks a little better...

i have a bottom end that looks a little better than that (but not by much) that i would get rid of.. although shipping would suck.
Forum: 2 smokers 11-02-2014, 07:58 AM
Replies: 116
Views: 5,401
Posted By stainlesscycle
i can see your point, but i personally have had...

i can see your point, but i personally have had no issues finding parts. there are several dealers that have been selling them for a long time, and have extensive parts inventories... sure you're...
Forum: 2 smokers 11-02-2014, 03:01 AM
Replies: 6
Views: 659
Posted By stainlesscycle
kinda - most 250/360/400 are the same diameter...

kinda - most 250/360/400 are the same diameter and spline from that era. the 100/125/175 are mostly the same also. the only real difference is the pinch bolt orientation and if it swivels at the...
Forum: 2 smokers 11-01-2014, 08:33 AM
Replies: 116
Views: 5,401
Posted By stainlesscycle
i have the same bike in 250cc it's neato.

i have the same bike in 250cc it's neato.
Forum: The Garage 10-31-2014, 04:10 PM
Replies: 17
Views: 1,290
Posted By stainlesscycle
there is a transfer clutch solenoid that could...

there is a transfer clutch solenoid that could fail in some automatics - that would possibly do what you're talking about at low speeds.. but the axles would be the first thing i would check.
...
Forum: The Garage 10-31-2014, 06:45 AM
Replies: 17
Views: 1,290
Posted By stainlesscycle
i could be completely wrong here too - but this...

i could be completely wrong here too - but this sounds like an axle issue - cv bind.. - yank in/out on the front axles and see how much play...
Forum: 2 smokers 10-30-2014, 08:38 PM
Replies: 9
Views: 968
Posted By stainlesscycle
ah, but that wasn't your cornering ability, it...

ah, but that wasn't your cornering ability, it was the low mounted footpegs that made it impossible to turn without dragging them in the dirt :)
Forum: Old's Cool 10-30-2014, 02:14 PM
Replies: 1,772
Views: 251,960
Posted By stainlesscycle
it is a good deal. does not appear to be hacked...

it is a good deal. does not appear to be hacked together, and appears to be well thought out - the styling is not my taste though. i bet he has 3x that into it.
Forum: 2 smokers 10-30-2014, 12:19 PM
Replies: 116
Views: 5,401
Posted By stainlesscycle
to me, a yz490 feels heavy and slow to steer. a...

to me, a yz490 feels heavy and slow to steer. a modern 2t does not. i feel significantly 'safer' on my modern 300 than i do on any big bore aircooled bike. probably due to the fact that the modern...
Forum: Thumpers 10-30-2014, 02:11 AM
Replies: 15
Views: 775
Posted By stainlesscycle
c49 means c49 high carbon steel, not the teeth...

c49 means c49 high carbon steel, not the teeth count. the last number of the part # is how many teeth. jtr210-48 is 48 tooth. can't tell from your pic if that's a 48 or a 43. fwiw jt also has an...
Forum: Thumpers 10-30-2014, 02:06 AM
Replies: 8
Views: 452
Posted By stainlesscycle
should be around $100 front and $100 rear.

should be around $100 front and $100 rear.
Showing results 1 to 40 of 500

 
Forum Jump

Times are GMT -7.   It's 05:54 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014