ADVrider

Go Back   ADVrider > Search Forums
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Showing results 1 to 40 of 302
Search took 0.02 seconds.
Search: Posts Made By: nella
Forum: Thumpers 09-07-2011, 10:21 AM
Replies: 22,164
Views: 2,678,271
Posted By nella
This is correct.

This is correct.
Forum: Thumpers 08-28-2011, 01:09 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
Got the rack from Jungleplant and installed it...

Got the rack from Jungleplant and installed it today.

Installation went smoothly but there was a small bit of interference with the exhaust can, so I made a wider spacer to move the muffler out...
Forum: Thumpers 08-24-2011, 04:32 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
Awesome! :thumb

Awesome! :thumb
Forum: Thumpers 08-23-2011, 05:51 AM
Replies: 22,164
Views: 2,678,271
Posted By nella
Very nice! Thanks. :thumb

Very nice! Thanks. :thumb
Forum: Thumpers 08-19-2011, 07:19 AM
Replies: 22,164
Views: 2,678,271
Posted By nella
If you have the CRF forks can't you just check...

If you have the CRF forks can't you just check and see if it works? If it bolts up then you would just check the rotor alignment between the pads and the diameter is appropriate.
Forum: Thumpers 08-18-2011, 08:20 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
Sounds like you are on the right track! :thumb ...

Sounds like you are on the right track! :thumb

Seems if you had an air leak it would be causing problems in addition to the idle. Anyway, spray WD40 on the rubber manifold boot while the engine...
Forum: Thumpers 08-18-2011, 02:47 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
I've got a set I'm considering selling and...

I've got a set I'm considering selling and thinking about the same question. Like anything, depends on condition and demand. I have seen good looking original front wheels go for as low as $100 and...
Forum: Thumpers 08-18-2011, 01:56 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
You can get a certificate of origin from Honda,...

You can get a certificate of origin from Honda, but it will be marked for off highway use only and will not likely be helpful.
Forum: Thumpers 08-18-2011, 01:55 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
The Sigma bike speedos are about the best for...

The Sigma bike speedos are about the best for motorcycle use because they register higher speeds. But by the time you do all the work you might just wish you had put a Koso or Trail Tech Endurance...
Forum: Thumpers 08-18-2011, 05:52 AM
Replies: 5
Views: 1,479
Posted By nella
I posted a response to your same question in the...

I posted a response to your same question in the XR650R thread. Before you mess with the jetting you need to make sure the carb is clean and everything else is in spec.
Forum: Thumpers 08-17-2011, 07:47 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
The Renazco is wider above where it bolts at the...

The Renazco is wider above where it bolts at the back but uses the stock XR650R pan. I will check tomorrow and PM you the measurements.
Forum: Thumpers 08-17-2011, 07:41 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
No rush at all Mike. Would be interested to...

No rush at all Mike.

Would be interested to know if it's possible for me to mount one of those fancy brackets on it for the modular gas tanks; is there enough clearance under it for that?

...
Forum: Thumpers 08-17-2011, 07:30 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
Lots of carb issues lately on the thread. ...

Lots of carb issues lately on the thread.

Are you sure you have the choke going in the right direction? I don't mean to offend you by asking, it's just that it's easy to think you have it open...
Forum: Thumpers 08-17-2011, 01:48 PM
Replies: 52
Views: 3,524
Posted By nella
We're too busy on advrider. You'd see a lot more...

We're too busy on advrider. You'd see a lot more dual sport thumpers if we could pry ourselves away from the computer and ride more. :D

In seriousness, we are but a small segment of the...
Forum: Thumpers 08-16-2011, 08:41 AM
Replies: 76
Views: 5,039
Posted By nella
Xr650l.

Xr650l.
Forum: Thumpers 08-16-2011, 08:25 AM
Replies: 4,163
Views: 689,768
Posted By nella
Dude, there's a tiny person stuck under your back...

Dude, there's a tiny person stuck under your back fender!




:D
Forum: Thumpers 08-15-2011, 05:54 PM
Replies: 354
Views: 61,722
Posted By nella
When you say the 20 needle is better what do you...

When you say the 20 needle is better what do you mean? What kind of mods does your bike have?

Thanks,
Forum: Thumpers 08-15-2011, 01:20 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
Nice looking bike! IMHO, a whole bunch better...

Nice looking bike! IMHO, a whole bunch better looking than a KLR.
Forum: Thumpers 08-15-2011, 04:03 AM
Replies: 22,164
Views: 2,678,271
Posted By nella
It's a deal, but I won't be able to do it until...

It's a deal, but I won't be able to do it until this weekend. I'll shoot you a PM.
Forum: Thumpers 08-14-2011, 04:30 PM
Replies: 3
Views: 1,525
Posted By nella
Nice write-up. Here's to another 50k miles. :beer

Nice write-up. Here's to another 50k miles. :beer
Forum: Face plant 08-14-2011, 02:30 PM
Replies: 6
Views: 2,618
Posted By nella
Now that's funny.:D I didn't say they were...

Now that's funny.:D

I didn't say they were good senses. After all, I take my XR650R on tight single track!
Forum: Face plant 08-14-2011, 01:53 PM
Replies: 6
Views: 2,618
Posted By nella
Right on! :thumb

Right on! :thumb
Forum: Thumpers 08-14-2011, 01:48 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
Your float needle is sticking and/or the float...

Your float needle is sticking and/or the float height is set incorrectly.

The high idle could be a symptom of the float needle not working correctly, but the gas coming out is a sure symptom of...
Forum: Face plant 08-14-2011, 09:20 AM
Replies: 6
Views: 2,618
Posted By nella
The benefits of a good helmet and body armor.

I went riding with a buddy yesterday and were in woods on some single track. I was on my XR650R.

Going down a hill and around a tree, my front tire slid out on some mud and I hit the tree...
Forum: Thumpers 08-14-2011, 09:01 AM
Replies: 22,164
Views: 2,678,271
Posted By nella
It is the idle cable. Best way to deal with it...

It is the idle cable. Best way to deal with it is turn it while you watch what happens, It might not have a positive stop as you back it out, I can't remember. I would screw it in several turns...
Forum: Thumpers 08-14-2011, 04:14 AM
Replies: 22,164
Views: 2,678,271
Posted By nella
Not long. You can remove the edelbrock's float...

Not long. You can remove the edelbrock's float bowl without removing the carb from the bike. Just remove the tank, loosen the clamps and rotate the carb so you can access the cap screws on the...
Forum: Thumpers 08-13-2011, 07:51 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
If it's stuck open the fuel won't be regulated in...

If it's stuck open the fuel won't be regulated in the bowl and it will overflow. if you have any fuel leaking out of the carb it's a problem and you need to go in and figure it out.

These...
Forum: Thumpers 08-13-2011, 07:46 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
I got my '02 with the stock carb. I thought the...

I got my '02 with the stock carb. I thought the throttle response off idle on the stocker was abrupt. The eddi really is smooth and the easy starts are a plus when cold or after a spill. I have my...
Forum: Thumpers 08-13-2011, 07:16 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
A properly working edelbrock should give you...

A properly working edelbrock should give you first kick starts. Sounds like you need to take it off, clean it and check the float and make sure that the float needle is not sticking. When you take...
Forum: Thumpers 08-10-2011, 11:52 AM
Replies: 22,164
Views: 2,678,271
Posted By nella
I had an intermittent problem with my XRR...

I had an intermittent problem with my XRR misfiring/running terribly after I landed a long jump one time. I at first thought it was a fuel problem or perhaps the cdi. I went through all the...
Forum: Thumpers 08-10-2011, 11:20 AM
Replies: 22,164
Views: 2,678,271
Posted By nella
In my looking around I could not find anyone who...

In my looking around I could not find anyone who has bought/reviewed his steel subframe either. It was interesting to look at his smugmug pictures...
Forum: Thumpers 08-09-2011, 08:18 PM
Replies: 5
Views: 652
Posted By nella
It's easy enough to inspect tires, wheels, chain,...

It's easy enough to inspect tires, wheels, chain, sprockets, and cosmetics for signs of damage and neglect. Beyond that each bike will have its unique problem areas and the only way to learn about...
Forum: Thumpers 08-09-2011, 08:03 PM
Replies: 7
Views: 722
Posted By nella
Seems like you have a good handle on it. ...

Seems like you have a good handle on it.

For the TAT and day after day of riding it seems you'd want a bigger dual sport in the 500-650 range (at least I would because I'm a big guy).

My view...
Forum: Thumpers 08-09-2011, 07:20 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
Put me in line, happy to test... Right now I...

Put me in line, happy to test... Right now I don't have any sort of rack and have been looking to buy.
Forum: Thumpers 08-09-2011, 08:26 AM
Replies: 22,164
Views: 2,678,271
Posted By nella
Baja designs has one here...

Baja designs has one here (http://www.bajadesigns.com/NET/P-128001/Switch,+Key+Switch+Kit-dsk)

I have one of their older keyed switches that I took off and replaced with a toggle switch. It was...
Forum: Thumpers 08-08-2011, 06:50 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
re racks: steel subframe and rack

Jungleplant,

I like this that somone posted a few pages back in this thread... steel subframe with integrated rack (http://shop.globetrottin.com/product.sc?productId=33&categoryId=14).

Just...
Forum: Regional forums 08-08-2011, 05:55 PM
Replies: 7
Views: 2,022
Posted By nella
This was blast last year and should be again this...

This was blast last year and should be again this year.

<a...
Forum: Thumpers 08-08-2011, 04:46 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
Bat Wing

+1

If some industrious soul starts bending the metal and making Bat Wings then please PM me. I don't have the bandwidth right now or I'd give it a shot.
Forum: Thumpers 08-08-2011, 02:22 PM
Replies: 22,164
Views: 2,678,271
Posted By nella
I want to put a bat wing on my XRR, just so I can...

I want to put a bat wing on my XRR, just so I can look at someone and say ".... in addition to all that I have a Bat Wing in the air box!" :thumb
Forum: Thumpers 08-07-2011, 10:18 AM
Replies: 22,164
Views: 2,678,271
Posted By nella
Very nice!

Very nice!
Showing results 1 to 40 of 302

 
Forum Jump

Times are GMT -7.   It's 09:59 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014