ADVrider

Go Back   ADVrider > Search Forums
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Showing results 1 to 40 of 53
Search took 0.01 seconds.
Search: Posts Made By: afordableperformance
Forum: Thumpers Yesterday, 05:31 PM
Replies: 4,669
Views: 800,797
So far so dry!

Rode it around some yesterday evening, parked it on a piece of cardboard and it looks to be dry, think the o-ring was the culprit, hope it stays that way and this helps someone else. Thanks
Forum: Thumpers 05-04-2015, 04:48 PM
Replies: 4,669
Views: 800,797
Thanks Geekventure, I had checked before and...

Thanks Geekventure, I had checked before and checked again today after work. Shifter shaft and everything else is dry. It is definitely being slung by the counter shaft sprocket, from the splines...
Forum: Thumpers 05-03-2015, 05:45 PM
Replies: 4,669
Views: 800,797
Small oil leak

I have a small oil leak that recently developed, seems to be around the counter shaft. I ordered/received the seal and the little o-ring behind the spacer. The seal is dry, looks like oil may be...
Forum: Thumpers 04-29-2015, 04:48 PM
Replies: 4,669
Views: 800,797
Side or Center Stand

I have searched all avenues and have not found either a side or center stand available. I would buy one of each if anyone ever decides to make or sell theirs again, seriously, let me know! I'm not a...
Forum: Thumpers 04-28-2015, 04:46 PM
Replies: 4,669
Views: 800,797
Centerstand!?

Hey Grinder, where can you find a centerstand for one these bikes? Thanks!
Forum: Thumpers 04-17-2015, 02:50 PM
Replies: 4,669
Views: 800,797
Thanks!

Thank You! That's exactly what I meant!:clap
Forum: Thumpers 04-17-2015, 01:40 PM
Replies: 4,669
Views: 800,797
Browneye! Thanks for the reply, looks like a cool...

Browneye! Thanks for the reply, looks like a cool place. I'm concerned when I haul the bike from a low altitude to a high altitude and not ride it through the climb. Without an 02 sensor will it...
Forum: Thumpers 04-16-2015, 05:55 PM
Replies: 4,669
Views: 800,797
630 at Altitude

I noticed a few pictures of 630's in higher elevations and wonder how the EFI works when the bike is hauled from a lower (1,200ft) to 12,000ft with the PU kit and no O2 sensor? I hauled a 2013...
Forum: Thumpers 03-26-2015, 06:24 PM
Replies: 4,669
Views: 800,797
I did the same thing!

I also sold my 2014 TR650 to buy a used 2011 TE630 and I have never looked back. For me the TE630 is a much better bike all around, except for the kick stand! It has better EFI, is lighter, better...
Forum: Thumpers 01-14-2015, 06:01 PM
Replies: 160
Views: 9,665
I'm not sure how to post pictures on this site,...

I'm not sure how to post pictures on this site, but if you or anyone will pm or email me your email address I'll send you a few pics no problem.
Forum: Thumpers 01-13-2015, 05:19 PM
Replies: 160
Views: 9,665
Should've Explained More

As the OP maybe I should've explained more, I started a list of things I thought would be neat on a modern bike, they are my personal preferences and they're not for everyone. I have been riding my...
Forum: Thumpers 01-12-2015, 05:42 PM
Replies: 160
Views: 9,665
What every dual sport needs......

I thought it'd be cool to share ideas of what I feel the best dual sport single should consist of today, maybe we'll get some good ideas out and a few may make it into production one day. I'd like to...
Forum: Thumpers 01-10-2015, 08:00 AM
Replies: 0
Views: 202
2007 Husqvarna 510 Clutch Available

For those of you that know, the 2007 510 has odd ball one-off clutch plates and they have been basically non-existent for a while now. My friend has a 2007 SM510 and has been in need of a clutch...
Forum: Thumpers 01-10-2015, 07:55 AM
Replies: 43
Views: 10,386
Te630

Go with the TE630! I had all of these bikes the 630 is much better than the 610, better EFI and turning radius. The Honda is good, just about as rare but has a carb, no E/S start and 5 speed plus not...
Forum: Thumpers 01-05-2015, 02:02 PM
Replies: 3
Views: 431
Altitude

I've been at several altitudes with many different bikes. 8000' will not be too bad, even stock, most newer bikes are lean anyway. 10,000' and above is when it becomes an issue. I have been going to...
Forum: Australia 12-02-2014, 05:44 PM
Replies: 35
Views: 1,528
Updated Info!

Thanks for the info so far, we don't plan to see the entire country by any means, we only have a week tops. I was just wondering which part of the country would be good for someone's first trip...
Forum: Australia 12-02-2014, 05:03 PM
Replies: 35
Views: 1,528
Vacation in Oz!?

Hello, we are considering visiting OZ next year if everything works out and am wondering where is the best area to go if we only have 5 or 6 days to stay? This is not a motorcycling trip, just sight...
Forum: Thumpers 11-21-2014, 06:41 PM
Replies: 4,669
Views: 800,797
Well?

How do you like it Grinder96, lots of low end power, huh!?:evil
Forum: Thumpers 10-31-2014, 01:17 PM
Replies: 4,669
Views: 800,797
I'm so glad you bought it, kept me from buying...

I'm so glad you bought it, kept me from buying another!!!!
Forum: Thumpers 10-30-2014, 05:09 PM
Replies: 4,669
Views: 800,797
Thanks

I ride 2-up in the rough stuff, like the low gear to get me out of situations and help on steep declines, more to keep my speed down and work the clutch less than anything else. I will order a 50...
Forum: Thumpers 10-30-2014, 03:10 PM
Replies: 4,669
Views: 800,797
Gearing Question

Hello, I recently acquired a 2011 TE630 and have a question about the chain and sprockets. The bike has 14/42 right now with a BRP rear guide. I want to gear it down very low, would like to run 14/48...
Forum: Thumpers 10-08-2014, 01:51 PM
Replies: 4,669
Views: 800,797
More Kickstand Info

Well, I didn't mean to open a can of Kickstand Whoop-ass! But it's good to see a few other fixes and ideas. My main problem with the kickstand is getting at it to lower it. I'm fighting to get it...
Forum: Thumpers 10-07-2014, 03:04 PM
Replies: 4,669
Views: 800,797
2011 te 630

Just spent a lot of time reading through this entire thread, WHEW!!!! I saw a local shop had a 2011 TE630 with 4200 miles, PU done and a few little extras, nothing extreme. After taking it for a...
Forum: Thumpers 08-14-2014, 05:27 PM
Replies: 32
Views: 5,685
I'll take one!

I'd take one of these and a Freeride 350 too! If they build it (and send it here) they will sell everyone they can make, we're starving to fill this gap in the US!
Forum: Thumpers 08-12-2014, 03:00 PM
Replies: 3
Views: 539
We Have a Winner!

:clapThanks GBAUTO! You got the movie right! There's not much useful information in the service manual for these little bikes, nothing like oil pressure or even the path of lubrication like many...
Forum: Thumpers 08-07-2014, 02:03 PM
Replies: 214
Views: 25,398
All About The Money

I agree with Trail Boss, it's all about the money, the Japanese bikes are already close in price to more premium bikes. That being said, there are still areas for improvement. I had a 2008 TE 610,...
Forum: Thumpers 08-06-2014, 01:40 PM
Replies: 3
Views: 539
Laugh Fixed!

170 Views and no replies!? "Thanks for ball your help"! If you know what movie that quote is from I'll tell what the problem was!
Forum: Thumpers 07-30-2014, 06:27 PM
Replies: 15
Views: 2,166
Straight KTM Rider!

Am I the only one that watched this and thought it really funny, or am just as sick as the OP!? Either way, I had a good laugh!
Forum: Thumpers 07-24-2014, 02:53 PM
Replies: 3
Views: 539
TTR125L Oil Pressure Odd Problem

I'm having an issue with a little 2001 Yamaha TTR125L and thought someone may have some insight for me as it's an odd issue. Got it 1 1/2 years ago in a
box, put it together and ran it a year...
Forum: Thumpers 07-20-2014, 12:51 PM
Replies: 2
Views: 650
AJP Motorcycles

Hello, I just recently stumbled across AJP Motorcycles and was wondering if anyone has any experience or knowledge of them? It looks like they plan on importing them from Portugal through Vermont,...
Forum: Thumpers 05-16-2014, 06:09 PM
Replies: 9,208
Views: 1,931,185
Passenger Pegs

There are a few good passenger peg options for the EXC 500, Globetrottin makes a cool rack combo with passenger pegs good for kids and Tec-Cycles makes a good set that piggybacks off the main pegs...
Forum: Thumpers 04-24-2014, 05:10 PM
Replies: 9,208
Views: 1,931,185
Horn Placement

I moved mine with the stock bracket to the screw hole in the intake, used the same screw that plugs the vacuum port when the canister is removed. Fits and looks great there, can email a pic if...
Forum: Thumpers 04-21-2014, 04:51 PM
Replies: 114
Views: 7,898
Technology

The 1980's was the dawn of liquid cooling, mono shocks and disc brakes, 1981 all the Big 4 started a form of their current mono set ups and disc brakes were just a year or two later. Even so, I know...
Forum: Thumpers 04-21-2014, 03:19 PM
Replies: 114
Views: 7,898
Being Cheap

I think the Big 4 are being cheap when it comes to making or improving new models. They have had many opportunities to make better bikes yet we continue to buy and live off 1980's technology. I know...
Forum: Thumpers 04-15-2014, 02:21 PM
Replies: 9,208
Views: 1,931,185
HDB Hand Guard Question

Hello, I have a 2014 EXC 500 and want to use HDB hand guards and mirrors but can't seem to get a few straight forward questions answered.

1) Can I use the threaded inserts in the stock KTM bars?...
Forum: Thumpers 04-14-2014, 03:57 PM
Replies: 6,328
Views: 843,547
Part 3?

Hi Dedave! Anxiously waiting for video 3! Thanks for all the work EVERYONE!
Forum: Thumpers 04-10-2014, 06:27 PM
Replies: 6,328
Views: 843,547
K&n

I would like to see a fix that can use the K&N filter, it's narrower and I've always liked them in the past. Is it possible that any adapters that accommodate the foam or stock filters will also hold...
Forum: Thumpers 03-23-2014, 03:06 PM
Replies: 6,328
Views: 843,547
Big Dog is right as usual! I test rode a new 690R...

Big Dog is right as usual! I test rode a new 690R Saturday and although the powertrain is awesome, the turning radius is horrendous even with the stops fully adjusted and I felt like I was fighting...
Forum: Thumpers 01-12-2014, 06:17 PM
Replies: 6,328
Views: 843,547
Hansi - I installed a cover on my rear brake...

Hansi - I installed a cover on my rear brake reservoir from a XR650L, cheap little Stainless guard costs like $8 and looks good, has the wrong bend on it but if you put it on before the bracket it...
Forum: Pics, pics, pics... 12-26-2013, 05:34 PM
Replies: 8,400
Views: 8,199,032
Try tilting your laptop, or should I say computer...

Try tilting your laptop, or should I say computer monitor!?:evil
Showing results 1 to 40 of 53

 
Forum Jump

Times are GMT -7.   It's 06:21 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2015