ADVrider

Go Back   ADVrider > Search Forums
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Showing results 1 to 7 of 7
Search took 0.00 seconds.
Search: Posts Made By: pkrasko
Forum: Thumpers 10-26-2008, 11:31 AM
Replies: 217
Views: 69,250
Posted By pkrasko
Bluhduh Thanks again

I'll grab a set of sockets and make sure it includes 22mm+

It went clank clank clank right when I pulled off the highway.
Turned the bike off, check around...attempted to use the electric start...
Forum: Thumpers 10-25-2008, 11:49 PM
Replies: 217
Views: 69,250
Posted By pkrasko
Crank shaft nut size

Thanks - that should work and will always come in handy later on...unlike the ktm flywheel spanner tool.

Do you happen to remember the size of the crank shaft nut? I know its probably larger than...
Forum: Thumpers 10-25-2008, 06:51 PM
Replies: 217
Views: 69,250
Posted By pkrasko
What a hell of a suprise....

My starter clutch went and I finally found the time today to take a quick look at what might be happening.

I took off the engine casing which hold the stator and found bolt heads stuck to the fly...
Forum: Thumpers 09-18-2008, 10:59 AM
Replies: 217
Views: 69,250
Posted By pkrasko
Thanks Everyone

All confusion has been cleared.
I really appreciate it.

I don't think I will lay the bike over to do this. It doesn't seem to make sense for a job that shouldn't take too long and then you have...
Forum: Thumpers 09-16-2008, 09:12 AM
Replies: 217
Views: 69,250
Posted By pkrasko
Type of ignition on KTM DUKE II LC4 2001 ?

I don't know too much about KTM's.

I looked up the part numbers for both the stator and the flywheel on my KTM DUKE II LC4 640 (2001)

SKU: 58439005100
FLYWHEEL KOKUSAN GP9128 '97

SKU:...
Forum: Thumpers 09-12-2008, 11:33 AM
Replies: 217
Views: 69,250
Posted By pkrasko
Flywheel Puller

Ok...next question.

Does anyone know the thread specs for flywheel/magneto extractor on LC4 640cc (01 DUKE II)?

26mm x 1mm right hand inner thread
M26x1 RHIT

Thanks
Forum: Thumpers 09-10-2008, 02:21 PM
Replies: 217
Views: 69,250
Posted By pkrasko
Flywheel / Magneto extractor

Hey does anyone know the part number for the flywheel extractor?

I think this one should do the trick. It's by MAC Tools and cost 1/3 of the price as the one from KTM.
...
Showing results 1 to 7 of 7

 
Forum Jump

Times are GMT -7.   It's 11:15 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014