ADVrider

Go Back   ADVrider > Search Forums
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Showing results 1 to 22 of 22
Search took 0.01 seconds.
Search: Posts Made By: Eats Dirt
Forum: Airheads 12-03-2013, 04:41 PM
Replies: 2,657
Views: 432,903
Posted By Eats Dirt
Hey Vernon, I PM'd you about the heads a week...

Hey Vernon, I PM'd you about the heads a week ago, please check.
Forum: Parallel Universe 11-22-2013, 04:35 PM
Replies: 194
Views: 62,118
Posted By Eats Dirt
k784 vs. TKC evaluation

Touratech evaluation.

http://www.touratech-usa.com/Adventure/Blog/SKEMKI/Product-Review-Kenda-Big-Block-Tires-on-BMW-R1200GS
Forum: Airheads 11-12-2013, 07:28 AM
Replies: 112
Views: 9,634
Posted By Eats Dirt
Replacement driveshaft

Regarding the replacement driveshaft made in Tiawan, it sounds like the fragility issue has been addressed in version 2.0 with the addition of Germany manufactured u-joints in same size of the joints...
Forum: Airheads 11-06-2013, 08:34 AM
Replies: 38
Views: 5,519
Posted By Eats Dirt
Does anyone have any new information for using...

Does anyone have any new information for using the Ignitech ignition on 247 boxer engines? I'm especially interested in setting curves using a throttle position sensor or pressure sensor. I looked at...
Forum: Ride reports 10-23-2013, 08:35 AM
Replies: 3,546
Views: 1,598,958
Posted By Eats Dirt
You get more valve area by increasing cylinder...

You get more valve area by increasing cylinder numbers. You might get more piston dome area too depending on aspect ratio. The down side is the more cylinders, the more friction.
Forum: Airheads 10-18-2013, 10:40 AM
Replies: 2,657
Views: 432,903
Posted By Eats Dirt
Wolfy, you're taking us in circles. Do you know...

Wolfy, you're taking us in circles. Do you know where we are?
Forum: Airheads 10-07-2013, 03:56 PM
Replies: 112
Views: 9,634
Posted By Eats Dirt
For a total measurement of______? I...

For a total measurement of______?



I think that the new, totally servicable drive shaft built in China or somewhere is the cheapest/best solution to the paralever drive shaft problem. Probably...
Forum: Airheads 10-07-2013, 03:25 PM
Replies: 112
Views: 9,634
Posted By Eats Dirt
How are people getting their replacement u-joints...

How are people getting their replacement u-joints in alignment so there isn't an out of balance vibration?
Forum: Airheads 10-06-2013, 01:04 PM
Replies: 112
Views: 9,634
Posted By Eats Dirt
Udates?

Has anyone sourced and used the ELBE 0.106.010 u-joint mentioned in the thread previously?
Forum: Airheads 09-20-2013, 07:38 AM
Replies: 2,657
Views: 432,903
Posted By Eats Dirt
WTB: /6, /7 rear wheel, rim.

I need a spoked rear wheel from a /6 or /7. Of course it needs to be in good shape with good splines, spokes and rim. I also need a rear rim from the same. Would also consider just a hub in good...
Forum: Airheads 09-19-2013, 10:10 AM
Replies: 2,657
Views: 432,903
Posted By Eats Dirt
/6 seat

Good grief guys, his post isn't even two days old.
Forum: Airheads 09-18-2013, 05:52 PM
Replies: 32
Views: 4,603
Posted By Eats Dirt
Do you have dyno results to share? What is...

Do you have dyno results to share?
What is your compression ratio?
What is your minimum fuel octane requirement?
Beautiful bike.
Forum: Airheads 08-01-2013, 08:09 PM
Replies: 2,657
Views: 432,903
Posted By Eats Dirt
WTB: R100GS solo seat rack

I have the solo seat, now I need the rack. What's out there? Please PM responses, I may not see them otherwise. Thanks.
Forum: Thumpers 04-11-2013, 06:58 PM
Replies: 6
Views: 1,039
Posted By Eats Dirt
I've been liking the Shinko 244 rear. As a new...

I've been liking the Shinko 244 rear. As a new tire it took me through lots of varied terrain in the Rocky Mountains almost as well as a knobby. I prefer the Michelin T63 street legal knobby to the...
Forum: Thumpers 03-29-2013, 11:25 AM
Replies: 3
Views: 713
Posted By Eats Dirt
Yup, side stand switch. I had just found in the...

Yup, side stand switch. I had just found in the manual that I had one when I read your response. The problem has now been permanently eliminated as it's certainly nothing this dirt bike needs!
...
Forum: Thumpers 03-29-2013, 10:42 AM
Replies: 3
Views: 713
Posted By Eats Dirt
2001 KTM 640 LC4 electrical problem

My bike dies as soon as I put it into gear.
1.) It starts and runs fine in neutral. The neutral light works.
2.) Thinking that it's the clutch switch, I took the switch out of the circuit using...
Forum: Vendors 01-17-2013, 03:13 PM
Replies: 8
Views: 768
Posted By Eats Dirt
Please and thank you!

Please and thank you!
Forum: GS Boxers 08-04-2012, 03:10 PM
Replies: 12
Views: 957
Posted By Eats Dirt
See your local auto upholsterer. Go to work...

See your local auto upholsterer. Go to work changing the foam on your stock seat pan until you get a shape that works, then get it covered. You might be surprised at the price compared to the big...
Forum: Thumpers 06-17-2012, 08:47 AM
Replies: 54
Views: 8,877
Posted By Eats Dirt
I'm looking at an Oh-six KLR with "appearance...

I'm looking at an Oh-six KLR with "appearance problems". Any new news on the project?
Forum: Equipment 06-03-2012, 05:42 PM
Replies: 30
Views: 3,941
Posted By Eats Dirt
I've hosted grackles in my garage wall for 22...

I've hosted grackles in my garage wall for 22 years now. I remember the hole in the siding every time I hear their young chirping in the wall and promptly forget to cover it after they move out. I...
Forum: Airheads 06-03-2012, 04:13 PM
Replies: 2,657
Views: 432,903
Posted By Eats Dirt
BMW airhead Progressive fork springs, NIB, p/n 11-1130

See details here:

http://advrider.com/forums/showthread.php?t=754507
Forum: Old's Cool 02-03-2012, 12:27 PM
Replies: 2,441
Views: 559,134
Posted By Eats Dirt
BMW airhead Progressive fork springs, NIB, p/n 11-1130

I have some NIB Progressive fork springs, for later airheads, for sale over in "Parts". Please contact me over there.

http://advrider.com/forums/showthread.php?t=754507
Showing results 1 to 22 of 22

 
Forum Jump

Times are GMT -7.   It's 12:56 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014