ADVrider

Go Back   ADVrider > Search Forums
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Showing results 1 to 40 of 114
Search took 0.01 seconds.
Search: Posts Made By: Gary Stofer
Forum: GS Boxers 05-14-2015, 08:48 AM
Replies: 4
Views: 283
Posted By Gary Stofer
On my high mileage '96 the cause was wear on the...

On my high mileage '96 the cause was wear on the bosses on the aluminum wheel hub. I solved the noise problem by placing the wave washer between the hub and the rotor instead of between the bolt...
Forum: GS Boxers 05-11-2015, 04:49 PM
Replies: 9
Views: 517
Posted By Gary Stofer
Push and rotate the wonder wheel at the same...

Push and rotate the wonder wheel at the same time. That will operate the zoom feature.
Forum: GS Boxers 05-07-2015, 06:45 PM
Replies: 9
Views: 507
Posted By Gary Stofer
Fuel filter?

Fuel filter?
Forum: GS Boxers 04-21-2015, 11:32 AM
Replies: 12
Views: 640
Posted By Gary Stofer
I installed R100GS pegs on my R1100GS. They're...

I installed R100GS pegs on my R1100GS. They're wider, longer and lower plus have a cushy rubber pad. Here's the details if you're interested:


R11XXGS TO 90-95 R100GS FOOT PEG CONVERSION
...
Forum: GS Boxers 04-18-2015, 12:28 PM
Replies: 20
Views: 1,452
Posted By Gary Stofer
I've owned both (Still have the 1100 with 250,000...

I've owned both (Still have the 1100 with 250,000 miles) The reasons I sold the 1150 include: A more complicated and difficult to replace throttle cable set-up that has more resistance to actuate. ...
Forum: GS Boxers 04-14-2015, 05:50 PM
Replies: 23
Views: 1,699
Posted By Gary Stofer
Not sure about the Chicago area but here on the...

Not sure about the Chicago area but here on the left coast Ace Hardware has a large assortment of open stock springs.
Forum: GS Boxers 04-07-2015, 04:44 PM
Replies: 4
Views: 300
Posted By Gary Stofer
The Laminar Lip is about 16" wide, 4-1/4" high in...

The Laminar Lip is about 16" wide, 4-1/4" high in the middle.
Forum: GS Boxers 04-07-2015, 12:47 PM
Replies: 4
Views: 300
Posted By Gary Stofer
If I recall correctly, it uses the stock mounting...

If I recall correctly, it uses the stock mounting hardware. I checked my 1150 Givi with Laminar Lip that is still hanging around and don't see any other hardware with it. As I remember it is a...
Forum: GS Boxers 04-01-2015, 05:26 PM
Replies: 27
Views: 1,170
Posted By Gary Stofer
Try wiggling the wires at the ignition switch. ...

Try wiggling the wires at the ignition switch. On my '96 the problem was in the switch (easily replaced), not the wiring harness.
Forum: GS Boxers 02-21-2015, 08:58 AM
Replies: 8
Views: 588
Posted By Gary Stofer
Thanks for the responses. They reaffirm what I...

Thanks for the responses. They reaffirm what I thought to be true. Our local dealer sent out an E-mail stating that brake fluid and clutch fluid should be changed every two years, thus prompting my...
Forum: GS Boxers 02-20-2015, 12:54 PM
Replies: 8
Views: 588
Posted By Gary Stofer
R1200GSW clutch fluid flush

Has anyone here done the clutch fluid flush on their GSW? I can see the bleed screw on the slave cylinder but have no idea how to access it without some significant disassembly.
Forum: GS Boxers 01-25-2015, 08:30 AM
Replies: 393
Views: 27,306
Posted By Gary Stofer
Had mine reprogrammed yesterday. I saw no...

Had mine reprogrammed yesterday. I saw no difference when riding. I have an early '13.
Forum: GS Boxers 12-15-2014, 03:56 PM
Replies: 393
Views: 27,306
Posted By Gary Stofer
They all do that. Or at least mine operate as...

They all do that. Or at least mine operate as you described.
Forum: GS Boxers 11-02-2014, 04:17 PM
Replies: 21
Views: 1,730
Posted By Gary Stofer
Replaced my m94 with an m97 in 1997, over 200,000...

Replaced my m94 with an m97 in 1997, over 200,000 miles ago. Never had another problem.
Forum: GS Boxers 10-16-2014, 08:48 PM
Replies: 11
Views: 1,342
Posted By Gary Stofer
It's only happened to my 1100 GS (248000 miles)...

It's only happened to my 1100 GS (248000 miles) once but after that time I always carried a spare.
Forum: GS Boxers 08-28-2014, 03:18 PM
Replies: 1
Views: 659
Posted By Gary Stofer
I had both a '96 R1100GS and a new '04 R1150GS at...

I had both a '96 R1100GS and a new '04 R1150GS at the same time. I sold the 1150 and still have the 1100 (248,000 miles on it). What I didn't like about the 1150 was: 1. Hydraulic clutch was...
Forum: GS Boxers 08-24-2014, 02:53 PM
Replies: 11
Views: 1,307
Posted By Gary Stofer
Valves are very easy to check. Invest in JVB's...

Valves are very easy to check. Invest in JVB's Service Video. Your dealer will probably use new valve cover gaskets ($$) which are not needed.
Forum: GS Boxers 06-30-2014, 11:54 AM
Replies: 31
Views: 3,124
Posted By Gary Stofer
Just ordered my Sargent for the WC this morning. ...

Just ordered my Sargent for the WC this morning. They said it would ship in about 2 weeks. Had one on an 1150GS and liked it. I also ordered the adjustable backrest. I had a Corbin seat/backrest...
Forum: GS Boxers 06-26-2014, 07:31 AM
Replies: 2
Views: 473
Posted By Gary Stofer
GS and R engines were identical. RT and RS were...

GS and R engines were identical. RT and RS were the same. The difference between the two engines was horsepower/torque. They should interchange without problems. Not so with internal parts such...
Forum: GS Boxers 06-09-2014, 09:17 AM
Replies: 11
Views: 824
Posted By Gary Stofer
Try pushing in on the wire connector at the...

Try pushing in on the wire connector at the switchgear. When mine failed (my dealer saw a communication fault on their $14000 computer even though everything was working when I took it in) I found...
Forum: GS Boxers 05-13-2014, 08:04 PM
Replies: 8
Views: 989
Posted By Gary Stofer
Yep. Don't worry, it's normal.

Yep. Don't worry, it's normal.
Forum: GS Boxers 04-15-2014, 02:07 PM
Replies: 7
Views: 1,050
Posted By Gary Stofer
I too got the "rejection" notice. My dealer...

I too got the "rejection" notice. My dealer didn't have a clue either.
Forum: GS Boxers 02-24-2014, 12:19 PM
Replies: 31
Views: 3,124
Posted By Gary Stofer
I had the exact problem as the OP and the...

I had the exact problem as the OP and the Wunderlich 35mm bar risers cured it. No problem mounting with the original cables/lines although I did clip the first tie wrap at the steering head just in...
Forum: GS Boxers 12-19-2013, 09:21 PM
Replies: 5
Views: 615
Posted By Gary Stofer
Beemer Boneyard come to mind.

Beemer Boneyard come to mind.
Forum: GS Boxers 12-13-2013, 10:02 AM
Replies: 19
Views: 1,952
Posted By Gary Stofer
Although it is rare, my '96 developed the same...

Although it is rare, my '96 developed the same problem. Finally traced down to the coils. Beemer Boneyard to the rescue. Problem solved.
Forum: GS Boxers 11-16-2013, 03:51 PM
Replies: 23
Views: 2,373
Posted By Gary Stofer
Early R1100GS oilheads were famous for blowing...

Early R1100GS oilheads were famous for blowing head gaskets resulting in oil leaks. The plastic fuel tanks would shed their decals and more than a few tanks collapsed due to emission control...
Forum: GS Boxers 11-01-2013, 02:35 PM
Replies: 3,081
Views: 471,558
Posted By Gary Stofer
Mine does not. It's an early bike delivered in...

Mine does not. It's an early bike delivered in March.
Forum: GS Boxers 10-19-2013, 11:22 AM
Replies: 11,475
Views: 2,307,040
Posted By Gary Stofer
Do you have the Enduro Pro plug installed? When...

Do you have the Enduro Pro plug installed? When it's fitted all settings should remain the same as you have selected when the bike is shut off.
Forum: GS Boxers 09-27-2013, 03:19 PM
Replies: 2,585
Views: 525,387
Posted By Gary Stofer
Our local dealer installs an SAE pigtail on the...

Our local dealer installs an SAE pigtail on the battery of all new BMW's so they can charge the batteries while the bikes are in the showroom. The use a multi battery Battery Tender Charger.
Forum: GS Boxers 09-25-2013, 07:34 PM
Replies: 10
Views: 1,004
Posted By Gary Stofer
My '96 oil temp sensor failed a long time ago. I...

My '96 oil temp sensor failed a long time ago. I could induce a failure by flexing the wires at the sensor. It was replaced under warranty (shows you how long ago). When it failed the engine...
Forum: GS Boxers 09-22-2013, 01:54 PM
Replies: 11,475
Views: 2,307,040
Posted By Gary Stofer
To reset the fuel consumption readings, just hold...

To reset the fuel consumption readings, just hold down the "Info" button. I reset #1 each time I fuel up. I leave #2 run. 8000 miles now and #2 reads 48 MPG
Forum: GS Boxers 09-20-2013, 04:29 PM
Replies: 14
Views: 2,124
Posted By Gary Stofer
I have the small BMW tank bag. It mounts easily,...

I have the small BMW tank bag. It mounts easily, holds enough for my purposes, and has an easy to use map pocket. And, surprisingly, was less than $200.
Forum: GS Boxers 08-20-2013, 08:21 PM
Replies: 3,081
Views: 471,558
Posted By Gary Stofer
Same wrench that fits the R1100/1150

Same wrench that fits the R1100/1150
Forum: GS Boxers 08-05-2013, 08:29 PM
Replies: 2
Views: 680
Posted By Gary Stofer
Yes, that is the typical failure mode for the M94...

Yes, that is the typical failure mode for the M94 transmission. I doubt it'll leave you stranded but it's time to find an M97 unit at Beemer Boneyard. My '96 GS would always exhibit that behavior...
Forum: GS Boxers 07-29-2013, 09:04 AM
Replies: 27
Views: 3,592
Posted By Gary Stofer
On my '96 GS I changed to Autolite AP3923s, broke...

On my '96 GS I changed to Autolite AP3923s, broke off pin #87 on the pink coding plug, reset the ECU by pulling the fuse....surging gone with maybe a 1 to 2 MPG penalty. Of course, then the ECU...
Forum: GS Boxers 07-29-2013, 07:25 AM
Replies: 11,475
Views: 2,307,040
Posted By Gary Stofer
Actually, the CHP insisted that the spoke wheels...

Actually, the CHP insisted that the spoke wheels be replace with cast wheels. Something about tire sizes and stability if I recall correctly. But they bent a lot of wheels as a result.
Forum: GS Boxers 07-28-2013, 01:23 PM
Replies: 11
Views: 708
Posted By Gary Stofer
I'd go for the '99. I have a '96 with 248,000...

I'd go for the '99. I have a '96 with 248,000 miles and never had any HE sensor problems. The transmission was changed to the M97 unit at 36,000 miles under warranty. The M94 trans can have...
Forum: GS Boxers 07-26-2013, 07:52 AM
Replies: 2,585
Views: 525,387
Posted By Gary Stofer
RichBMW, there is no interference between the...

RichBMW, there is no interference between the Wunderlich 35mm bar-backs and the small BMW tank bag.
Forum: GS Boxers 07-22-2013, 02:06 PM
Replies: 2,585
Views: 525,387
Posted By Gary Stofer
RichBMW, it's always best to use a torque wrench...

RichBMW, it's always best to use a torque wrench but you can get by without. You'll have a pretty good idea how tight the original bolts were when you disassemble. Make sure you tighten down the...
Forum: GS Boxers 07-22-2013, 09:30 AM
Replies: 2,585
Views: 525,387
Posted By Gary Stofer
The 35mm up & back bar risers fit with no...

The 35mm up & back bar risers fit with no modifications to brake/clutch lines or wiring. I did remove the first cable tie at the frame just to give a little more slack.
Showing results 1 to 40 of 114

 
Forum Jump

Times are GMT -7.   It's 11:20 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2015