ADVrider

Go Back   ADVrider > Search Forums
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Showing results 1 to 22 of 22
Search took 0.01 seconds.
Search: Posts Made By: pandemonium
Forum: Old's Cool 03-14-2011, 08:20 PM
Replies: 32
Views: 1,764
Posted By pandemonium
Thumb Some good reading there.

Some good reading there.
Forum: Old's Cool 03-14-2011, 06:47 PM
Replies: 32
Views: 1,764
Posted By pandemonium
This is good stuff too!

This is good stuff too!
Forum: Old's Cool 03-14-2011, 06:44 PM
Replies: 32
Views: 1,764
Posted By pandemonium
Cool. I will read the valve adjustment artical...

Cool. I will read the valve adjustment artical and hopefully will at least have that starightened out. Thanks.
Forum: Old's Cool 03-14-2011, 03:27 PM
Replies: 32
Views: 1,764
Posted By pandemonium
The Enricheners Should be correct. I don't know...

The Enricheners Should be correct. I don't know how to set the float levels. I'm going to go over the carbs again anyway after valve adjustment and timing.

[/QUOTE]You say the bike lagged...
Forum: Old's Cool 03-14-2011, 03:10 PM
Replies: 32
Views: 1,764
Posted By pandemonium
who said i wasn't taking your advice?! i have...

who said i wasn't taking your advice?! i have shown much appreciation time and time again for all the suggestions. You are judging me very unfairly.

i am a newcomer here and i bought the bike...
Forum: Old's Cool 03-13-2011, 09:04 PM
Replies: 32
Views: 1,764
Posted By pandemonium
ooohh... those valves!:)

No, the valves I have not checked. I need to do some more research before I am ready for that. Any guidance is appreciated.

I just want to clarify one thing. I may have been vauge in the above...
Forum: Old's Cool 03-13-2011, 05:46 PM
Replies: 32
Views: 1,764
Posted By pandemonium
By valves, do you mean jets? When I rebuilt...

By valves, do you mean jets?

When I rebuilt the carbs I rinsed the jets with lighter fluid (what i had on-hand), poked the bristols of a plastic brush through the holes, and blew them out with...
Forum: Old's Cool 03-13-2011, 05:14 PM
Replies: 32
Views: 1,764
Posted By pandemonium
Hhmmm... Sounds promising. Perhaps i will try...

Hhmmm... Sounds promising. Perhaps i will try this out tonight if laziness/distractability do not get the better of me.
Forum: Old's Cool 03-12-2011, 10:19 PM
Replies: 32
Views: 1,764
Posted By pandemonium
yeah. I checked for spark after last post... it...

yeah. I checked for spark after last post... it sparks, but plugs should be changed. As for fuel, it seems as though gas ran out on the right side of the tank, and only the left cylinder was...
Forum: Vendors 03-12-2011, 05:13 PM
Replies: 23
Views: 6,214
Posted By pandemonium
hahahahahahaa:rofl:rofl:rofl priceless.

hahahahahahaa:rofl:rofl:rofl

priceless.
Forum: Old's Cool 03-12-2011, 04:00 PM
Replies: 32
Views: 1,764
Posted By pandemonium
...nothing i worked on affects its ability to...

...nothing i worked on affects its ability to start (i.e. breaks, throttle cables, oil). Also, it ran fine after... for a while anyway.
Forum: Old's Cool 03-12-2011, 02:07 PM
Replies: 32
Views: 1,764
Posted By pandemonium
Pissed The story goes like this: Bought the bike...

The story goes like this:

Bought the bike (r90/6), ran fine. Rode it a little after getting it home, all seemed well. Replaced throttle cables, break pads and rotor; changed engine oil.

Went...
Forum: Old's Cool 03-12-2011, 01:23 PM
Replies: 32
Views: 1,764
Posted By pandemonium
intermittent neutral light...

...could this be the result of a faulty neutral switch?
Forum: Old's Cool 03-12-2011, 09:59 AM
Replies: 20
Views: 1,584
Posted By pandemonium
yeah and even better, i had the carb rebuild kit...

yeah and even better, i had the carb rebuild kit on-hand and was able to fix it that night.:D
Forum: Old's Cool 03-12-2011, 09:55 AM
Replies: 86
Views: 14,579
Posted By pandemonium
Hey Mike, Congrats, on the new/old machine! ...

Hey Mike,

Congrats, on the new/old machine! I recently purchased a 1976 R90/6 myself (my intro to the airhead world).

Is the stain on the ground (in pics 1 and 2) from your carb leaking? Mine...
Forum: Old's Cool 03-10-2011, 09:35 PM
Replies: 20
Views: 1,584
Posted By pandemonium
Yup, that's what it was. Rebuilt the carbs, and...

Yup, that's what it was. Rebuilt the carbs, and now it runs better.:clap

Now to sync...
Forum: Old's Cool 03-09-2011, 04:10 PM
Replies: 20
Views: 1,584
Posted By pandemonium
Tell me more about the neutral switch. What am i...

Tell me more about the neutral switch. What am i Looking for?
Forum: Old's Cool 03-09-2011, 10:32 AM
Replies: 20
Views: 1,584
Posted By pandemonium
Drummer dude, I think you are on to something. ...

Drummer dude, I think you are on to something. The engine speed does NOT climb/increase when i pull the throttle at high speed. Would this be the result of a gummed-up main jet?

I also want to...
Forum: Old's Cool 03-08-2011, 11:17 PM
Replies: 20
Views: 1,584
Posted By pandemonium
Yeah. I tried adjusting it. The clutch cable...

Yeah. I tried adjusting it. The clutch cable was very tight and i thought that it might not be fully engaging. Still had the problem even after loosening the cable.

I have read that a good way...
Forum: Old's Cool 03-08-2011, 11:04 PM
Replies: 20
Views: 1,584
Posted By pandemonium
Good question. I am very unfamiliar with...

Good question. I am very unfamiliar with airheads, as i have only had the machine two weeks and most that time it spent on jack stands in the garage while i was doing the other work plus new tires...
Forum: Old's Cool 03-08-2011, 10:22 PM
Replies: 20
Views: 1,584
Posted By pandemonium
i replaced the pan gasket because there was oil...

i replaced the pan gasket because there was oil on the bottom of the pan, not a steady leak, not a steady leak but i figured it couldn't hurt to replace it. There does seem to be some oil on the...
Forum: Old's Cool 03-08-2011, 09:29 PM
Replies: 20
Views: 1,584
Posted By pandemonium
Cry Slippery Clutch, uh oh...

Hey all,

First time poster here. I recently aquired a 1976 BMW R90/6. As a new Airhead owner I have come here to stand on the shoulders of those who have come before, and seek some advice on...
Showing results 1 to 22 of 22

 
Forum Jump

Times are GMT -7.   It's 12:09 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014