ADVrider

Go Back   ADVrider > Search Forums
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Showing results 1 to 40 of 92
Search took 0.01 seconds.
Search: Posts Made By: positionsize
Forum: Thumpers 01-31-2013, 11:00 PM
Replies: 34
Views: 2,305
Posted By positionsize
Pissed Loud exhaust WILL SAVE YOUR LIFE!

RTW trip in undeveloped countries?
OP should seriously consider having a VERY Loud exhaust and forget the Beta male tree hugger BS.

I ride mostly in the Philippines and here, as in most 3rd...
Forum: Orange Crush 09-08-2012, 10:34 PM
Replies: 5
Views: 842
Posted By positionsize
??

Did you ever get this resolved?

:lurk
Forum: Vendors 09-09-2011, 01:48 AM
Replies: 42
Views: 6,977
Posted By positionsize
Question Can I Customize?

Greetings,

I am ready to pull the trigger on an Explorer Deluxe Asym ZIP.

Are the ZIP. available yet or still back ordered?

Also, Is it possible to customize my order like I can on the...
Forum: Orange Crush 09-04-2011, 04:18 PM
Replies: 26
Views: 2,082
Posted By positionsize
1+ I suspect it's bad gas - or varnished...

1+

I suspect it's bad gas - or varnished carbs.

If you gas is not fresh, I would completely drain the tanks and put fresh gas.
Add some SeaFoam to the new gas and ride for a while.
SeaFoam...
Forum: Orange Crush 05-03-2010, 04:02 AM
Replies: 48
Views: 2,728
Posted By positionsize
Its your carb vents

1+ :thumb

Had the same surging issue when I first got my 9fidy.

Inspect the vent tubes routing and length.

http://www.advrider.com/forums/showthread.php?t=526932&highlight=carb+vents
Forum: Thumpers 03-27-2010, 07:09 PM
Replies: 24
Views: 1,317
Posted By positionsize
I have had this happen a few times when...

I have had this happen a few times when installing new meat on the rear of my XR200R.

Overpressure and soap had no effect. The only way I can ever get it to seat evenly is to spoon off one side...
Forum: Orange Crush 06-25-2009, 01:01 AM
Replies: 16
Views: 1,696
Posted By positionsize
If the canisters gone, I would guess your Jets...

If the canisters gone, I would guess your Jets are clogged from fuel varnish. I would pull the carbs and thoroughly clean them.

For a quick fix you can try adding Seafoam to the gas.

Seafoam...
Forum: Orange Crush 05-12-2009, 03:31 PM
Replies: 6
Views: 703
Posted By positionsize
I actualy found the fuel spray while I was...

I actualy found the fuel spray while I was setting up to sync the carbs. Syncing had no effect.


Am I wrong in assuming that I shold not be able to see any fuel spraying out from between the...
Forum: Orange Crush 05-12-2009, 11:18 AM
Replies: 6
Views: 703
Posted By positionsize
Needle Jet problem 950a

I have a 06 950A. I am getting some moderate spark knock under load below 3000 rpm. I belive I have found the cause. While looking down the bell of the rear carb, I noticed fuel spraying or leaking...
Forum: Orange Crush 05-10-2009, 11:18 PM
Replies: 6
Views: 801
Posted By positionsize
Rice

The easiest method I have used to clean the expansion tank is to remove it, put about 1/8 cup of ucooked white rice in the tank along with an ounce or two of water and either vinegar, dish soap or...
Forum: Orange Crush 05-10-2009, 03:43 PM
Replies: 7
Views: 602
Posted By positionsize
Needle Jet

Well.........I pulled the low octane map wire and it had no effect.

Next, I synced the carbs. They were out of sync but not an unexpected amount considering that the valves were just adjusted,...
Forum: Orange Crush 05-10-2009, 10:39 AM
Replies: 7
Views: 602
Posted By positionsize
Havent done this yet because I dont have a Carb...

Havent done this yet because I dont have a Carb Syncronizer handy. Im not sure if un-synced carbs would could cause spark knock. I found a home made Carb Syncronizer tool HERE...
Forum: Orange Crush 05-09-2009, 12:52 PM
Replies: 7
Views: 602
Posted By positionsize
Spark Knock 950A

Greetings everyone,

I recently added a 950A to the stable. :D
Its a 2006 with 3,700mi when I bought her. The guy I bought it from is an Inmate here. He bought the bike from the original owner...
Forum: Orange Crush 04-19-2009, 08:52 AM
Replies: 132
Views: 28,429
Posted By positionsize
Thanks For the link Mate! Exactly what I...

Thanks For the link Mate!

Exactly what I was looking for :thumb
Forum: Orange Crush 04-18-2009, 11:45 AM
Replies: 132
Views: 28,429
Posted By positionsize
Clicking sound

Greetings Everyone,

I am checking the Valves on my new to me 2006 950A and have a few questions.

When rotating the engine to TDC anti-clockwise via the Allen Head inside generator cover I...
Forum: Orange Crush 03-31-2009, 09:54 PM
Replies: 17
Views: 1,083
Posted By positionsize
If you don't find it elsewhere, any SCUBA Dive...

If you don't find it elsewhere,
any SCUBA Dive shop will have silicon grease.
Forum: Thumpers 12-29-2008, 06:28 AM
Replies: 266
Views: 72,354
Posted By positionsize
. :lurk

.



:lurk
Forum: Thumpers 12-28-2008, 06:15 AM
Replies: 266
Views: 72,354
Posted By positionsize
One more other relevant link

Look at Post #7

KTM 640 Adventure hesitation or stalling just off idle (http://www.advrider.com/forums/showthread.php?t=397653)
Forum: Thumpers 12-28-2008, 05:52 AM
Replies: 266
Views: 72,354
Posted By positionsize
I had the same frustrating issue on my 2004 640A....

I had the same frustrating issue on my 2004 640A.

IMHO. The most likely solution is ?................Drill your slide to 3mm :wink:

Check out this thread.

KTM 640 Adventure LC4 - Bogs off...
Forum: Thumpers 12-15-2008, 08:21 AM
Replies: 23
Views: 1,447
Posted By positionsize
Have a look in the following 2 threads. They...

Have a look in the following 2 threads. They might be helpful.


http://www.advrider.com/forums/showthread.php?t=114703


...
Forum: Thumpers 11-13-2008, 04:01 PM
Replies: 7
Views: 678
Posted By positionsize
Wow! :eek1 I thought that would be near...

Wow! :eek1

I thought that would be near impossible.
Did it brake your flanges or bend the plug when it blew?

I am curious if you used the original flange on the left side when you first...
Forum: Thumpers 10-20-2008, 04:35 PM
Replies: 42
Views: 4,471
Posted By positionsize
Have you removed you SAS ?

After correcting any exhaust leaks, if you sill have decal popping it is likely a product of your SAS. The SAS introduces cooler air from the cylinder head into your exhaust on deceleration causing...
Forum: Thumpers 10-20-2008, 03:03 AM
Replies: 42
Views: 4,471
Posted By positionsize
A few questions about you setup

First off, I would suggest you raise the Idle to 1600 -1700 RPM.

Have you already installed a KTM racing side airbox cover (or removed the snorkel) and replaced the stock exhaust (or at least...
Forum: Thumpers 06-18-2008, 03:45 AM
Replies: 72
Views: 7,038
Posted By positionsize
Option B. Part it out

Sad to hear of your LC4 misfortune.

Just a thought about an other option.

At those prices you might consider abandoning any thoughts of repairing your 2001 and just part it out.

In the end...
Forum: Thumpers 06-03-2008, 02:35 PM
Replies: 28
Views: 2,702
Posted By positionsize
Pissed LOL :rofl :rofl Ridden more than one...

LOL :rofl :rofl

Ridden more than one KLR:puke1............ I own a 2004 640A

Perhaps holycaveman's assessment is technically correct but in reality my KTM feels like twice the HP of any...
Forum: Thumpers 05-31-2008, 10:39 PM
Replies: 1,979
Views: 320,459
Posted By positionsize
Excellent

Post of distinction

:thumbup

Thanks Laramie
Forum: Thumpers 03-31-2008, 10:25 PM
Replies: 13
Views: 26,977
Posted By positionsize
2008 Honda XR 200

2008 Honda XR 200 Sold in Philippines
Forum: Thumpers 03-31-2008, 10:22 PM
Replies: 13
Views: 26,977
Posted By positionsize
Parts are no problem

Greetings Dieseldave24v,

I am an American expat living here in Philippines. I own a 2004' XR200 I purchased new here. Honda still sell new XR200's (XLR) in the Philippines for p111,900 Pesos which...
Forum: Thumpers 03-05-2008, 03:46 AM
Replies: 11
Views: 2,740
Posted By positionsize
04's dont have it.

I have a High Flo 2004 Adventure and it does not have this oil line on the front of the motor. Bung only.

They must have introduced this line in 05'.
Forum: Thumpers 03-02-2008, 07:49 AM
Replies: 266
Views: 72,354
Posted By positionsize
Good work Coughinhk getting rid of the surge...

Good work Coughinhk getting rid of the surge problem. :clap


I moved my needle clip up 1 notch back to the stock position and my minor bog is 90% better. I am a little confused as to why it runs...
Forum: Thumpers 02-25-2008, 12:47 PM
Replies: 266
Views: 72,354
Posted By positionsize
Tps

Thanks for the explanation Potatoho


Hey Coughinhk

I have been following your process closely. I have a similar situation. I wouldn’t call my condition a surge. It is more like an off idle...
Forum: Thumpers 02-25-2008, 11:56 AM
Replies: 266
Views: 72,354
Posted By positionsize
O2 analyzer

Would you please elaborate on how to do this? Where/how do you hook up(exhause tip?) I have an 02 analyzer I use for analyzing 02 enriched breathing gases for SCUBA but im guessing this type of...
Forum: Thumpers 02-23-2008, 10:45 PM
Replies: 21
Views: 1,227
Posted By positionsize
The universal key blank code is ZD23RCP-FI. ...

The universal key blank code is ZD23RCP-FI.

I heard that the key blanks for LC4 are also used on Volvo cars. Try your local Volvo dealer.
Forum: Thumpers 02-22-2008, 01:34 PM
Replies: 6,231
Views: 1,142,884
Posted By positionsize
Try filling the tank more. I sometimes have...

Try filling the tank more.

I sometimes have this problem on my 2004 640a. I discovered once im on reserve, if I only add in a few liters (3-4 liters)of gas to the tank the "tank empty" light goes...
Forum: Thumpers 02-18-2008, 12:09 AM
Replies: 72
Views: 16,211
Posted By positionsize
Thank for the offer tdv. I have already installed...

Thank for the offer tdv. I have already installed a Staintune Slip-on and I am very happy with it. I have also performed the standard performance mods suggested by so many on this site. My 640a not...
Forum: Thumpers 02-17-2008, 11:48 PM
Replies: 28
Views: 4,045
Posted By positionsize
Reading this post brought up a troubling question...

Reading this post brought up a troubling question for me.

When I recently re-sealed my rocker cover I remember moving the rocker arms on the shafts back and forth a bit. There was some play. Only...
Forum: Thumpers 02-17-2008, 10:38 PM
Replies: 72
Views: 16,211
Posted By positionsize
A pic of the 'finished' exhaust

A pic of the 'finished' exhaust.
Forum: Thumpers 02-17-2008, 10:36 PM
Replies: 72
Views: 16,211
Posted By positionsize
What came off

What came off
Forum: Thumpers 02-17-2008, 10:23 PM
Replies: 72
Views: 16,211
Posted By positionsize
Thumb I belive Coughinhk has found the answer to...

I belive Coughinhk has found the answer to modifying the European Silencer (N0N-Supertrap model)that is Stock on the 640Adv and 640SM delivered to Europe and Australia.:clap


The link to his...
Forum: Thumpers 02-11-2008, 09:36 PM
Replies: 80
Views: 7,395
Posted By positionsize
I belive the metal washer belongs on the bottom...

I belive the metal washer belongs on the bottom of the plastic washer.
You might consider putting in you spare stock setup needle with the clip second from the bottom then plastic washer and metel...
Showing results 1 to 40 of 92

 
Forum Jump

Times are GMT -7.   It's 08:26 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014