View Single Post
Old 08-05-2009, 05:00 PM   #9
johngil OP
Reseda, CA
 
johngil's Avatar
 
Joined: Jun 2007
Oddometer: 3,714
Quote:
Originally Posted by itsatdm
I felt concerned enough about this to pull my shock bolt and luckily it is OK. The measurement I got between the mounting flanges was 2 3/4 in. The stock shock spacer is 1 3/8in and whole set up seemed to be a poor design. Then I pulled the rubber seat latch and noticed it too had a spacer. When the bolt is tighted to spec the two flanges butt up to one another and should provide a good reinforcement to the bolt. So not as bad as I thought.
I can see that if an aftermarket shock did not have a spacer as wide as the stock one, there would be no reinforcement for the bolt and it could bend which in turn could bend the crossmember.
For the stocker to do that, it looks like it had to be under a lot of pressure, had an improper spacer installed or a frame not to spec in width.
The Ohlins re-uses the stock spacer.
johngil is offline   Reply With Quote