View Single Post
Old 08-06-2009, 03:31 PM   #46
rivercreep
Banned
 
Joined: Feb 2007
Location: S.E. Pennsylvania (Reading)
Oddometer: 3,243
Go back through this thread and re-read my comment

Quote:
Originally Posted by DSdave
Should valves be adjusted to the tighter or looser of the range?

I just read that too tight can cause idle problems due to longer durations, mostly stalling at stoplights, true or not?
What other differences does it make?

On the flywheel, there is a line with the letter T to the right of it. So I'm guessing TDC is when the line is centered in the sight hole?
Sorry to sound snotty but, this question has already been answered.
In regards to the question about stoplight stalling, if things are within the specified specs, (not too tight or loose) stalling isn't an issue and if it IS....something else is wrong. (most likely, carb-float heighth).
rivercreep is offline   Reply With Quote