View Single Post
Old 09-03-2009, 07:49 PM   #216
Bayner
Beastly Adventurer
 
Joined: Mar 2008
Location: Penticton, BC
Oddometer: 1,489
Question

It's not going to be obvious by eyeballing it. The bearings need to be removed from the hub, and measurements taken (vernier caliper) to confirm the lengths are in very close tolerances. If the weather here sucks on the weekend, I may just do this...

I have to ask myself, did the same company machine the rear spacer as did the front axle??!!
Bayner is offline   Reply With Quote