Next up is the Powerlet plug. It went smoothly. I Doubled up on the ACC so I could also wire the GPS to this one.
I used the Low profile socket.
I bought an extra connector that I didn't need as the kit comes with the other half of the modex type deal shown in the bottom left of the picture.
It was a tight fit and there's a bit of interference with the seat (Renazco) but not much. Over all I'm happy with the placement.
I ran the wires along the right side of the head tube and while doing so re-routed the wires from the grip heaters to that side too. Its cleaner this way and leaves the clutch hose plenty of room.
I'll get to the GPS next and add more on this later.