View Single Post
Old 10-28-2009, 11:07 AM   #33
toplessFC3Sman OP
Adventurer
 
Joined: Oct 2009
Oddometer: 68
The stator/cover should be arriving today, so I can begin to get an idea of how to go about mounting that later this evening.

As for the throttle bodies, I'll be cutting the one in half, and using the cable mounting and pivot arm bits from the CL350 carbs to actuate each throttle, instead of having to worry about extending the pivot arm. There's also the option of just cutting the fuel rail and welding nipples onto each side so that I can run some hose between, cutting this to length. I'll need to figure out some brackets to hold the now loose end of each individual rail down, but this shouldn't be too bad.
toplessFC3Sman is offline   Reply With Quote