View Single Post
Old 12-02-2009, 12:43 PM   #76
*kartman* OP
GO Bacon GO !
 
*kartman*'s Avatar
 
Joined: Dec 2008
Location: Cottbus, Germany
Oddometer: 397
And another update ;)

Checked and cleaned the parts


I also mounted a new (used) front rack, because there was a weld broken at mine...


Then I build in the motor
There were a few little problems ...
The srew from the oil line in the front of the engine knocked against the frame and therefore I could get it in the right position.
But after some filing this wasn´t a problem any more ^^



All pipes are built on, coolant and engine oil is in...
Vacuum connection for the fuel pump and temperature switch for the warning light are also fitted.

Filling and venting the clutch


Built on some parts


This is how it acutally looks...


Installed a new jet needle


The next thing I want to do is buying an Akrapovic full exhaust system
I also noticed that the Magura clutch armature doen´t fit with the old light / indicator switch - I´m going to buy a CEV switch, which is a lot smaller...
*kartman* is offline   Reply With Quote