View Single Post
Old 12-16-2009, 07:21 PM   #21
farmer fred
Banned
 
Joined: Aug 2006
Oddometer: 1,493
Quote:
Originally Posted by zookster
I've posted this request before several months ago. I thought I had scored a usable master cylinder off evilbay, but turns out that one is pitted beyond use too.

So I'm back to square one, in need of a good, usable rear master cylinder for a 1975 Guzzi T-3. Many tonti framed bikes used this type MC, up til about 1980 will work I think.

I have a rebuild kit on hand, so it doesn't have to be perfect, just have a good bore. I could go the sleeve route but would rather not.

This is the type I'm looking for:


PM me if you have one available and thanks in advance!
I went down the same road you did, and ended up buying one just as pitted as the one I had. I ended up having Apple Hydraulics sleeve it in brass and it worked fine. Good luck.
farmer fred is offline   Reply With Quote