View Single Post
Old 12-29-2009, 10:09 AM   #14
toowheels OP
on a mission...
 
toowheels's Avatar
 
Joined: Mar 2006
Location: Vancouver, BC
Oddometer: 934
TreeFarmer; Thanks for the comment! It's a little hard to tell in the first pic but the rack does indeed have a taper to it. You can get more of a perspective with the bigger pic below.

F800 Rob; Yip the current plate worked with Touratech (and most probably Git) engine bars only. Some people like the increased coverage and think I should do two versions. Any thoughts y'all? There seems to be a lot of the Git set up out there and I think a good part of that is the front and side coverage of their skid plate.
I was allowed to post in Beasts 'cause it was a plea for help as I was looking for people with various types of engine bars to fit the prototype skid plate with, and to get feedback. It is also because these are prototype parts we are talking about. When they are in production they will go to Vendors.

Dave
www.motooverland.com


__________________
Moto Overland [MOD] -Skid Plates, Top racks, Tool Boxes etc for Adventure bikes
& Giant Loop for Canada

www.motooverland.com

toowheels screwed with this post 12-29-2009 at 10:29 AM
toowheels is offline   Reply With Quote