View Single Post
Old 01-07-2010, 02:47 PM   #78
2on2off OP
Head'n somewhere new
 
2on2off's Avatar
 
Joined: May 2007
Location: Central California
Oddometer: 1,229
Quote:
Originally Posted by A.Vern
This is different than the final bearing failure that can happen. The hex bolt that came out should need a heat gun to remove. The PO had the same problem but I think red locktite would of kept it in. Other wise the bike was a champ, did fine on the ice. I think the GSA knew we were heading towards Lippencott at Sundown and said Eff that
You guys know how to ride that ice and on a GSA and without bearings

You know how to not let a little ice or bike failure spoil you fun.......The GSA doesn't need no sticking bearings........it's a tank........
__________________
Jim
I came to ride...........

2on2off screwed with this post 01-13-2010 at 06:40 PM
2on2off is offline   Reply With Quote