View Single Post
Old 01-18-2010, 10:35 AM   #9
DirtJack
Adventurer
 
DirtJack's Avatar
 
Joined: Aug 2007
Location: San Antonio, Texas
Oddometer: 1,086
Quote:
Originally Posted by cybbe
yes there is a some problems to get it to work with the "no frame", but i have allso seen many solve greater problems than that here

suspension is mounted from factory!
center stand is not.. ill solve it and come back ...
Maby there is no room for a centerstand with all your luggage mods hihi.

thanks anyway all of you...
If I were going to do it (probably wouldn't as I removed the center stand on my old LC4 so I could install a side-stand), I would start with a metal skid-plate (I use a Flatland on my 690) and weld up an "H" stand out of small size tubing. Then weld rod tabs to the top of each side of the H. The rods would fit inside two short pieces of tube (sized to make a simple plain bearing) which would be welded/bolted to the bottom rear part of the skid-plate. Use something simple (KTM rubber band) to hold the stand up. Should only decrease ground clearance by 3/4" as measured from under the foot-pegs.
__________________
Remember, you're reading this on the Internet and it was written by a guy who can remember stuff which never happened.
2014 KTM 1190 Adventure R
2008 KTM 300 XC (plated)
2008 KTM 690 Enduro
DirtJack is offline   Reply With Quote