View Single Post
Old 01-21-2010, 08:16 PM   #17
cybbe OP
n00b
 
cybbe's Avatar
 
Joined: Apr 2007
Oddometer: 9
Thumb hi again!

Dont resign yet, haha...(thx for the drawing allso)
I really didnīt think that i would get this good response! thx
About the pictures, well i can take a few picures an post them or maby some one else is faster than me can take some shots.

I have not yet bought a alu skidplate so thats no problem.
And im sure if I ask they can make one special out of 5mm aluminium in the bottom of it. Or ill just make my own in stainless.

I dont remember how the 640 centerstand looked like but im sure its gonna be something like that, but the rear break stuff is sure in the wrong place..

So thanks all of you and ill comeback with some pictures, dont leave the discussion if im delaying a few days
maby something like this centerstand skidplate can be made... http://www.klr650.com/strdCenSt.htm or not...

(i hope you can read my crap english)

//johan

cybbe screwed with this post 01-21-2010 at 08:24 PM
cybbe is offline   Reply With Quote