Originally Posted by r00t4rd3d
I was just googling for one a month ago. My reasoning is my bike is starting to get heavy cause of my racks and boxes and it sits in the garage for extended periods of time cause of the horrible winters we have here. When I work on my bike I also like it to be straight up and down and with the side stand that dont happen.
I shoved this piece of cardboard up under there and traced what I think you need then I sized it to be the exact size as the real measurements , so if you print it out it will be the real size and measurable. Are these the numbers you wanted ?
I checked on this today. It is not close enough for 400 stand to fit. The upper mount captures the cross braces and locks on. The angle has to be a good match. This keeps the stand from moving out of position forward or backwards and prevents twisting.
The good news is that from your drawing I could probably make one. I would need you to verify the diameter of the cross tubes. They are usually a tad smaller then 5/8".
I will send you a PM.