View Single Post
Old 03-02-2010, 07:53 AM   #1
CurlyMike OP
Formerly SaddleSoar
 
CurlyMike's Avatar
 
Joined: Feb 2008
Location: east of Dallas
Oddometer: 982
Airhead electrical Question. Circuit Board

This is for my latest resurrection. Its off of a 1975 R75/6. I spent a couple of minutes straightening all of the “pins” and even cleaned them all with my Dremel and a small wire brush. Sprayed contact cleaner on the front and back and am ready to start plugging. (Note: The picts are before the cleaning and the straightening). When it comes to electrical I just kind of shut down.

The contact pins that obviously have a strip in the back were somewhat loose, not overly, and not all of them. Is them being loose going to inhibit the boards functionality? Should I drop some solder on each to sure them up? Am I over thinking the function and the way these work? Can I test each with a voltmeter? How?
__________________
Giving the horses and the wife a break from riding...

CurlyMike screwed with this post 12-13-2010 at 07:15 AM
CurlyMike is offline   Reply With Quote