View Single Post
Old 03-07-2010, 07:02 PM   #60
netjustin's Avatar
Joined: May 2009
Location: Monterey, CA USA
Oddometer: 89
Originally Posted by Bart
Valve floating would be an issue. Also connecting rods in those days were not designed to take the loads of such high revs............ for very long.

Just my 2 cents
Call me crazy, but I think valve float should never be an issue if your springs are properly spec'd and still doing their job. Then again you probably know more about this motor than I do. Wouldn't take much. :)
netjustin is offline   Reply With Quote