View Single Post
Old 03-14-2010, 03:27 PM   #12
jsrider
Beastly Adventurer
 
Joined: Jun 2004
Oddometer: 3,495
Quote:
Originally Posted by Head2Wind
one way is if the inner bearing was not pressed in all the way, but then the large inner clip would not of been able to engage the cover.... impeller could have been loose on the shaft? or not seated all the way down?
IIRC a few folks had problems with loose impellers on the early bikes and had similar ground-down impeller blades.
jsrider is offline   Reply With Quote