I started my high fender install today. The fender went on fine but I can't seem to get a handle on how to modify the left fork guard to work in conjunction with the ABS sensor. Do you end up cuting off the plastic arm that retains the wire to the ABS sensor so that you can get this guard to fit behind it? Which bolt holes on the guard did you use and which did you modify? If someone has a close up picture it would be really appreciated!!
Other options.... Has anyone use something like a rubber tube type cover for the fork instead (like they used on the KLR)? Or has tried cutting the OEM fender off and trim it down to leave the original sides as the fork guard portion? My big concern with this is that it may be to flimsy then.