[DeeGee]

I fitted the master cylinder seal kit. After a few problems with the clutch I suspected the slave had let go so I bought one of these babies in blue of course





Anyway after fitting it the dragging and not getting into neutral still persisted so I went and got the seal kit and fitted it today.



Leaking





I unbolted the mirror and took the lever out, then took the master cylinder off the bars, emptied the master cylinder and cleaned it out.



Removing the circlip was a total PIA, but managed to get it out. Be warned if you are going to carry out this minor overhaul be careful when you remove the circlip as the spring behind it will fire the seal out with a good squirt of oil

Replace the spring and seal, fasten everything back onto the bars and re-bleed the clutch.
Test ride tomorrow