View Single Post
Old 05-13-2010, 04:03 AM   #2
JRWooden
Beastly Adventurer
 
Joined: Jul 2008
Location: The great state of confusion
Oddometer: 4,112
Well I would not have thought it ... but there appear to be several ways to screw this up..........







and .... as I have ALWAYS come to expect, the manual (Rev. #4) leaves me wanting more information..........

Right off I see:

Pic - 1) I'm not QUITE sure what they mean when they say install... wide/narrow drivers ... maybe this would be more clear if had the parts in front of me...

Pic -1) note the sharp edge of the plates goes IN ... not sure why this matters, and would not guess that this is your problem, but since you are in there anyway ... I'd do it like they say...

Pic 2 & 3) Note that some "construction groups" have a segmented thrust washer which might or might not be replaced with a NON-segmented thrust washer, or might be discarded completely as it indicates the new construction status does not use it?

It does give what I would call a "stack height" dimension well TWO of them actually ... 46.3 / 44.9mm so you could see if what you've got matches either of those.... If yours is thicker than 46.3 ... that would explain what you are seeing ........ If you discard the thrust washer it looks like the stack is supposed to be 1.4mmm thinner ....

Also ... note the F658GS has different shoulder washer bits......
I wonder if the spring preload is less on the 658?

Well I'm sure I've cleared everything up for you now eh?
JRWooden is offline   Reply With Quote