View Single Post
Old 07-10-2010, 11:32 PM   #41
veetwo _tls
RENOVATIO:
 
veetwo _tls's Avatar
 
Joined: Nov 2005
Location: FNQLD innisfail/SOUTH OZ murray bridge
Oddometer: 1,824
Quote:
Originally Posted by WARRIORPRINCEJJ
The lever is held in place with a bolt that has an 8MM head...if I remember correctly. Your tool kit should have a socket (and extension, if needed) to fit this...I believe the kit has a 6MM, 8MM, and 10MM socket.

Once again, if I remember correctly, upon re-installation, KTM recommends a certain kinda' "thread compound" for the bolt. It is a "Loc-Tite" part number of some sort. I couldn't find it, in my area. So, I just used medium strength "Permatex" threadlocker (P/N 24200).

I always believe that a person should follow the manufacturer's recommendations. However, since I could not find the Loc-Tite thread compound, I went with the Permatex...and haven't had a problem. I am not saying that you should do this...only that I did it without any drama.


EDIT: Good ol' veetwo beat me to it...faster fingers...


.

sorry


http://www.loctiteproducts.com/p/10/...r-Blue-242.htm
__________________
Sent from my HTC ONE X - Using Rooted S-OFF , Open Home 6 & Buuf icon pack
http://forum.xda-developers.com/ BUILD YOUR OWN PHONE
CHEERS: brett
MY07 950 SER
veetwo _tls is offline   Reply With Quote