View Single Post
Old 07-28-2010, 02:29 PM   #3326
valvecrusher OP
tractus pro pensio™
 
valvecrusher's Avatar
 
Joined: Feb 2007
Location: Dos Circlos
Oddometer: 1,663
fixing the kickstand/lean

If your NX250 is about to fall over to the right side, or maybe it just
stands 'too upright'...then falls to the right...



It makes you worry....
as when dismounting you never seem to find the 'sweet spot' of level ground,
that will allow you comfort of mind that your NX250 is NOT going to fall over to the right

Well, here is the 'fix'(click to enlarge, as always)

Flip the kickstand 'plate' 180º,
(before the flip)
which will require a bolt with a much shallower bolt head...

After this modification,
the plate will need to travel over and across the bolt's head,
which it cannot do with the stock item, as the bolt head is too tall.


I used a cut down hex head bolt

(After the flip)

Now your NX250 is going to lean to the LEFT, or at least, not as much upright..
Cheers!

valvecrusher screwed with this post 07-29-2010 at 09:04 AM
valvecrusher is offline   Reply With Quote