View Single Post
Old 08-02-2010, 12:04 PM   #32
ebrabaek OP
Beastly Adventurer
 
Joined: Jan 2010
Location: Grand Valley, Colorado
Oddometer: 4,639
Here it is ....after a little sanding........


On the bike......Looks like the fit is good....




Then as always..... You improvise as you go along....And after sanding the inside..... I though... I have a little leftover kevlar...... Perhaps If I give it one more layer on the inside..... The lighter color would yield more reflection of heat from the engine.....rather than absorb it. At least that`s how it works in the sun.......... It will also have a little better finish......although ....nobody are going to see the inside when it is mounted.........So on went another 125 g of resin.........and Kevlar.....

Back out in the sun...... But I really like the way it looks on the bike.....

Erling
ebrabaek is offline   Reply With Quote