This was going to be my 4th fuel pump replacement and I didnít want to buy a new one for $155.00 or go down the Facet pump fix. So I did some research and thanks to some fellow inmates I found a set of replacement contacts for the OEM fuel pump. It took me less than 1/2 of an hour to replace them and it only cost me $50.00.
You can order the contacts at http://www.moto-services.net/search.php
Part number 18-4615
Shakin_Jake found them here for $43.00
And here is a link to a how to. http://www.cbrforum.com/forum/showthread.php?t=102151
Here are a few other tips to help you get it done.
1. Remove the old contacts by removing the two screws and desolder the black pump motor lead.
2: When istalling the new contacts be sure to get the top pivot plate into the grove on the pump shaft.
3: Secure the screws and resolder the pump motor lead.
4: Before you replace the cap be sure that the cable stop (black rubber grommet) is seated all the way into the cap. I used some silicone spray to get it seated.
5: Silicone the cap and the screw. WATER TIGHT!
6: The right side is the inlet. You may want to connect the pump wire and turn your key on to make sure it works before hooking up the fuel lines.
And it's that simple.