View Single Post
Old 09-14-2010, 10:50 AM   #43
ebrabaek OP
Beastly Adventurer
 
Joined: Jan 2010
Location: Grand Valley, Colorado
Oddometer: 4,674
So in anticipation of the ups truck arriving with the CF today...... I took off the fairing...... And cleaned up the bike.





Put the fairing ( now two layers of cf+ foam pieces).....and made a nice work stand....... Cleaned the edges a little, so the next 3 layers will conform nicely......





It is almost impossible to NOT bend the edges....corners of the wet cf cloth when they rest on the bike ( or any piece) It is better to have the wet cf cloth hang over about 1 inch all around, so not to9 have any sharp bends.
I am hoping to add the 3 layers tonight, so I can begin the most fun part tomorrow...... The shaping. But... Tonight is movie night, and I just finished calibrating our new processor....... So Prince of Persia will sound awesome........ Until then ......



Erling
ebrabaek is offline   Reply With Quote