View Single Post
Old 09-17-2010, 01:22 PM   #57
ebrabaek OP
Beastly Adventurer
 
Joined: Jan 2010
Location: El Paso,NM
Oddometer: 4,594
Time to cut the screen...... Used a 2 amp dremmel......router bit....and went for it..... Poor little thing...... I had to cool the little thing 4 times with compressed air........ Measeured, and taped.....200mm...


Ready....set....go.....



After the first side is done...... Note.... Went in two stages to get the with...



Arrrrggggggggggggg....... The toes........again.....

Ok...... I need your help....... I am going bonkers deciding weather or not to put up the screen. I thought as I go along with the groove cutting....etc.... The solution will present itself. The skinny...... I totally love the look of the fairing only. Every time I look at it from any side....but mostly riding....he-he.....
I could just leave it.... The wind breaks just under my neck....and leaves my head in mostly clean air. When I rode with the stocker...( about same size)... Although the wind had diminished.... There were the turbulence....just a little....never the less..... It was there. The other side......I think the screen breaks the nice lines of the screen........Wadayathink??????

In the down possition.....


In the up position......












Pleeeeeeeeeeeeeeeeeeeeezzzzze....

Erling
ebrabaek is offline   Reply With Quote