View Single Post
Old 09-30-2010, 03:09 PM   #5
ebrabaek OP
Beastly Adventurer
 
Joined: Jan 2010
Location: El Paso,NM
Oddometer: 4,374
In routing the wires....I found it much easier to feed the loom through the 7/8 inch hole I just drilled....If I took apart the feed connector..... You use a small screw driver to push on the little pin inside....then the plug slides out....


Then after feeding it....when you put the connector back together....this is the little tap you bend in the prior step....bend it back again....insert the prong in the plug.... Note where plus and minus is....


This is how it looks out of the housing.....


Then zip tie the wires in the front...






Then re-check all is working.....




Time for a few shots of espresso.....wait until darkness.....I`l post a few pictures later.......

Erling
ebrabaek is online now   Reply With Quote