View Single Post
Old 11-02-2010, 02:09 AM   #28
yamahaman OP
wannabe bike builder
 
yamahaman's Avatar
 
Joined: Jul 2010
Location: melbourne Australia
Oddometer: 223
Talking what a productive long weekend

Well I managed to get the donor bike/engine running today after a new set of rings and valve stem seals so this made room on the bike stand for the project build.


So I have had some expert input from a couple of scottish/irish/italian friends of mine who's input has been invaluable. Some good ideas from these two nutbags. Managed to work out the linkage angles for the lower dogbone and I have a solution for the lower bolt removal but all I did was prepare for the linkage to be installed and prepared the tubing to fit the wr subframe



All I have to do is tack this tube in and make the lower sub frame mounting points and the lower linkage mounting points. Easy!!!!!!!!!!!!!!!
__________________
Build it and you will ride

My crazy bike build

yamahaman screwed with this post 11-02-2010 at 02:54 AM
yamahaman is offline   Reply With Quote