View Single Post
Old 11-13-2010, 03:52 PM   #63
cjracer OP
AWD please!!
cjracer's Avatar
Joined: Sep 2005
Location: Mukwonago, WI
Oddometer: 3,974
Now that I have a cutter, I need to do some final prep on the fixturing.

You can see here that the bolt and nut are sticking up a little above the top of the head tube.

I need to cut as deep as possible to get through the frame tubes clean.

I milled off the stud and nut.

I sure hope this works.... Safety glasses on, this job might need a helmet...

Final program test before reloading and indicating again. I forgot to get some measurement off the frame that I would need for later, so I had to unclamp the frame, then refixture it. Once it's cut off, no turning back.

And action.


Nice and clean cut. Slow and steady worked out great, to my relief.
My 2006 950S thread. 2006 950s update
New product updates here! Wordpress BLOG
click for the full line of products. FREE STUFF!!

cjracer screwed with this post 11-13-2010 at 04:06 PM
cjracer is offline   Reply With Quote