View Single Post
Old 11-25-2010, 11:00 AM   #44
LaPorte
Gnarly Adventurer
 
LaPorte's Avatar
 
Joined: Jul 2006
Location: Northern Ca.
Oddometer: 484
Quote:
Originally Posted by Monstaman
I have not got an 8 yet but can anyone tell me the parallel length on the fork tube machining that will allow the fork to be bought up through the triples to lower it, I am vertically challenged thus I am curious to find this out, many thanks Andi.
Monstaman

I am vertically challenged also. If you look at the top of the forks you will see a grove on the fork tube showing what I thought was the max you can raise the forks in the clamps. I have gone another 1/2" past the line. At that point, if you were to use all of your fork travel the front fender and brake lines would just be touching the under side of the bike's Radiators and such. Raising your fork tubes any higher and you could cause problems.

LaPorte
__________________
If you don't know where your going don't lead!
LaPorte is offline   Reply With Quote