View Single Post
Old 05-09-2005, 01:44 PM   #9
Still alive...
creeper's Avatar
Joined: Dec 2003
Location: Puget Sound
Oddometer: 10,718
Well if you're only going to have one... I suppose a 0-75 3/8 drive would do.
An inch pound 1/4 drive is to insure accuracy with the smaller, low torque value fasteners that are much easier to strip or break if you over torque them... something that would be very easy to do with a less than high quality, wide spread 3/8 drive foot pound wrench set a low value... understand?
So... how's tricks?
creeper is offline   Reply With Quote