View Single Post
Old 12-26-2010, 02:39 AM   #66
yamahaman OP
wannabe bike builder
 
yamahaman's Avatar
 
Joined: Jul 2010
Location: melbourne Australia
Oddometer: 223
Wink machining the brake brackets

Went to a mates place to do the finishing touches on the rear master/footpeg backet. After laramine LC4 had a few questions/surgestions I am going to move the master inboard approx 4mm. Also there was a heap of excess material taken off to reduce some weight



Here we are removing some material to make the back of the bracket flat in preperation for turining it over to machine the other side parrallel



Here we are removing 4mm from the bracket so the master and pedel will not protrude too far out from the bike. Not quite finished tonight so we will finish them tomorrow and have a go at fitting them in the next few days.

__________________
Build it and you will ride

My crazy bike build
yamahaman is offline   Reply With Quote