View Single Post
Old 01-04-2011, 08:26 PM   #5
cleatusj OP
Dirt floor engineer
 
cleatusj's Avatar
 
Joined: Dec 2010
Location: Granbury, TX
Oddometer: 1,098
Here's a shot of the subframe mounted on bike. I used the same type brackets on the opposite motor and center stand mounts except longer so that I could bolt through and into the 1/2" plug welded nuts inside the 1" sq. tube. There are also plug welded nuts in both the front and back ends of this to attach the car frame.

And another view (blurry)of swing arm from bottom.
cleatusj is offline   Reply With Quote