View Single Post
Old 01-09-2011, 05:57 AM   #7
booger1 OP
Studly Adventurer
 
booger1's Avatar
 
Joined: Mar 2010
Location: Arizona
Oddometer: 805
Now that the motor is built, it's time to get the thing mounted. The top mount is way off and the bottem mount is close.





I cut the bottem brackets off and bolted them to the motor, this well locate them correctly on the frame when I weld them back on.



Tacked into place.



A little tip here for all of you that may want to do this. This tubing is very thin and easy to blow through. I aslo descovered that there was moisture in there. There are drain holes on the back of the frame, but still higher up. Something I may address later.
__________________
Eating_goat_with_the_Cartel , Never_ventured_never_gained
oncostaricantime , boundlessbooger , 1998xr400buildwithe-start
Good judgment comes from experience. Experience comes from bad judgment - Mark_Twain

.
booger1 is offline   Reply With Quote