Quote:
Originally Posted by 3uba296
Cool, good to know. What about people saying yoy could get 500cc out of the 350 engine?
|
I bored mine out to 450 and the engineers that did the sleeve and boring said it would be entirely possible to go to 500 with the room that was left.
The kit I used came from LA Sleeve and just maybe their sleeves are a bit thinner.
I just went out and measured a set of cases I have and the case hole was 98.26 mm so with that you could fit a sleeve that was damn close to 98 don't yer think???? With your figures that would leave a 4mm sleeve thickness. Stock thickness just measured at 3.5 mm.